Removing The Left Endcover - HP 200 Service Manual

Removing the Left Endcover

1 Remove the window D page 6 15, and the center cover D page 6 16.
2 Remove the two screws on the left front trim and the two screws on the left back trim.
Torx-15
Reassembling: When replacing screws on any plastic part, always begin
C A U T I O N
by gently twisting the screw in anticlockwise with your hand, until the
screw finds the thread path and clicks, and then twisting the screw in
clockwise with your hand, before using a screwdriver. This is to avoid
cross threading. Do not over tighten the screws.
6 Remove the three screws from the left
side of the left endcover.
Torx-15
3 If the plotter is mounted on legs, loosen
the two left hand screws that attach the
plotter to the legs.
6 18 Removal and Replacement
4 Maintaining an even pressure on the top
and bottom of the endcover, pull it to the
left, away from the plotter.
Do not let the window pivot spring drop out
of the endcover
C3187 90000