Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Asus ZenPhone 6
Summary of Contents for Asus ZenPhone 6
- Page 1 User Manual...
- Page 2 Product warranty or service will not be extended if: (1) the product is repaired, modified or altered, unless such repair, modification of alteration is authorized in writing by ASUS; or (2) the serial number of the product is defaced or missing. ASUS PROVIDES THIS MANUAL “AS IS” WITHOUT...
-
Page 3: Front Features
Thank you for purchasing this ASUS product! Before you start, ensure that you have read all the safety information and operating instructions in this User Manual to prevent injury or damage to your device. NOTE: For the latest updates and more detailed information, please visit www. -
Page 4: Side Features
Side features Audio jack Volume key Power Key Groove Micro USB port NOTE: Pry open the rear cover from the groove. -
Page 5: Rear Features
Rear features Rear camera Flash Rear cover Speaker NOTES: • Remove the rear cover to display the dual micro SIM and microSD card slots. • The micro SIM card slots support WCDMA, DC-HSPA, and GSM/EDGE network bands. • The microSD card slot supports microSD and microSDHC card formats. -
Page 6: Charging Your Zenfone
Charging your ZenFone 6 After installing your micro SIM card, we strongly recommend that you charge your device fully before powering it ON. To charge your ZenFone 6: Connect the USB connector into the power adapter’s USB port. Connect the other end of the micro USB cable to your ZenFone 6. - Page 7 NOTES: • Use only the power adapter that came with your device.Using a different power adapter may damage your device. • Using the bundled power adapter and ZenFone 6 signal cable to connect your ZenFone 6 to a power outlet is the best way to charge your ZenFone 6.
- Page 8 Turning your ZenFone 6 on or off Press the power key at the side of your ZenFone 6 to power the device on or to power it off. Power key IMPORTANT: The first time you power on your ZenFone 6, you will see the Welcome screen.
-
Page 9: Installing A Micro Sim Card
Installing a micro SIM card To install a micro SIM card: Locate the groove on the bottom-left corner of your ZenFone 6. Pry the cover loose and then pull the rear cover off. Insert the micro SIM card into one of the slots. - Page 10 Replace the rear cover. Press down the rear cover on all sides to secure it in place. IMPORTANT: • Both micro SIM card slots support 3G WCDMA network band. But only one micro SIM card can connect to 3G WCDMA service at a time. •...
-
Page 11: Installing A Microsd Card
Installing a microSD card To install a microSD card: Locate the groove on the bottom-left corner of your ZenFone 6. Pry the cover loose and then pull the rear cover off. Insert the microSD card into the microSD card slot. - Page 12 Replace the rear cover. Press down the rear cover on all sides to secure it in place.
-
Page 13: Ce Rf Exposure Compliance
CE RF Exposure Compliance This device meets the EU requirements (1999/519/EC) on the limitation of exposure of the general public to electromagnetic fields by way of health protection. For body-worn operation, this device has been tested and meets the ICNIRP guidelines and the European Standard EN 62209-2, for use with dedicated accessories. -
Page 14: Specific Absorption Rate (Sar)
Specific Absorption Rate (SAR) Band Position SAR- 10g (W/kg) GSM900 Head 0.367 Body (1.5cm Gap) 0.397 GSM1800 Head 0.306 Body (1.5cm Gap) 0.325 WCDMA I Head 0.187 Body (1.5cm Gap) 0.248 WCDMA Head 0.190 VIII Body (1.5cm Gap) 0.211 2.4G Head 0.303 WLAN... -
Page 15: Prevention Of Hearing Loss
Prevention of Hearing Loss To prevent possible hearing damage, do not listen at high volume levels for long periods. À pleine puissance, l’écoute prolongée du baladeur peut endommager l’oreille de l’utilisateur. For France, headphones/earphones for this device are compliant with the sound pressure level requirement laid down in the applicable EN 50332-1:2000 and/or EN50332-2:2003 standard required by French Article L.5232-1. -
Page 16: Safety Information
-10 °C (14 °F) and 35 °C (95 °F). IMPORTANT! To provide electrical insulation and maintain electrical safety, a coating is applied to insulate the ASUS ZenFone 6 body except on the sides where the I/O ports are located. - Page 17 The battery Your ZenFone 6 is equipped with a high performance non-detachable Li-Ion battery. Observe the maintenance guidelines for a longer battery life. • Do not remove the non-detachable Li-on battery as this will void the warranty. • Avoid charging in extremely high or low temperature.
- Page 18 NOTES: • Risk of explosion if battery is replaced by an incorrect type. • Dispose of used battery according to the instructions. • Ensure to fully charge the battery before using your ZenFone 6 for extended periods. Remember that the power adapter charges the battery as long as it is plugged into a power source.
-
Page 19: Driving Safely
• If cleaning is necessary, turn your ZenFone 6 off and wipe carefully with a soft, slightly damp (not wet) cloth. Use a cotton swab to clean the camera lens. Allow your ZenFone 6 to dry completely before switching it on. Never use solvents for cleaning. -
Page 20: Electronic Devices
In the interest of safety, we would recommend the use of a cradle while using any form of handsfree accessory. While driving, we recommend that you use voicemail wherever possible, and that you listen to your messages when you are not in the car. -
Page 21: Other Medical Devices
ZenFone 6 immediately. Hearing aids Some digital phones may interfere with some hearing aids. In the event of such interference, call ASUS Customer Service to discuss alternatives. Other medical devices If you use any other personal medical device, consult the manufacturer of your device to determine if it is adequately shielded from external RF energy. -
Page 22: Magnetic Media
Magnetic media Magnetic fields generated by mobile devices may damage data on magnetic storage media, such as credit cards, computer discs or tapes. Do not place your ZenFone 6 next to such media. You should never expose your ZenFone 6 to strong magnetic fields as this may cause temporary malfunction. - Page 23 Areas with a potentially explosive environment are often, but not always, clearly marked. They include fuelling areas such as gas stations, below decks on boats, fuel or chemical transfer or storage facilities, vehicles using liquified petroleum gas (such as propane or butane), areas where the air contains chemicals or articles, such as grain, dust, or metal powders, and any other area where you would normally be advised to turn...
-
Page 24: Operator Access With A Tool
• Do not disassemble the ZenFone 6 or its accessories. If service or repair is required, return the unit to an authorized service center. If the unit is disassembled, a risk of electric shock or fire may result. • Do not short-circuit the battery terminals with metal items. - Page 25 Fax: 886228907698 Declaration We declare that the IMEI codes for this product, ASUS ZenFone 6, are unique to each unit and only assigned to this model. The IMEI of each unit is factory set and cannot be altered by the user and that it...
-
Page 26: Ec Declaration Of Conformity
Manufacturer: ASUSTeK COMPUTER INC. Address, City: 4F, No. 150, LI-TE Rd., PEITOU, TAIPEI 112, TAIWAN Country: TAIWAN Authorized representative in Europe: ASUS COMPUTER GmbH Address, City: HARKORT STR. 21-23, 40880 RATINGEN Country: GERMANY declare the following apparatus: Product name :... - Page 27 ASUSTeK COMPUTER INC. Strada PEITOU Nr 150, Li-TE etaj 4, TAIPEI 112, TAIWAN Adres, Ora: ar: Taiwan Reprezentant autorizat în Europa: ASUS COMPUTER GmbH Adres, Ora: Strada HARKORT Nr 21-23, RATINGEN 40880 ar: Germania declarm c urmtorul aparat: Nume produs:...
- Page 28 15060-31000000...