Table of Contents
Advertisement
Beeper Definitions (Continued)
Table 2-1
Beeper Sequence
Code 39 Buffering
High/low beeps
3 long high beeps
High/low/high beeps
Low/high/low beeps
Low/high beeps
Host Specific
USB only
Low/medium/high beeps
upon scanning a USB device
type
Low/medium/high beeps
occur more than once
RS-232 only
1 short high beep
New Code 39 data was entered into the buffer.
Code 39 buffer is full.
The Code 39 buffer was erased.
The Code 39 buffer was erased or there was an attempt to clear or transmit an
empty buffer.
A successful transmission of buffered data.
Communication with the host must be established before the digital scanner
can operate at the highest power level.
The USB host can put the digital scanner in a state where power to the
scanner is cycled on and off more than once. This is normal and usually
happens when the PC cold boots.
A <BEL> character is received and Beep on <BEL> is enabled.
Data Capture
Indication
2 - 3
Advertisement
Table of Contents
