How To Copy The Disk Basic - Sharp MZ-700 Basic Manual

15
,
key is registered by this file name on the supported master disk.
In addition, because the NEW command is at the end of this program, "READY" is
displayed after execution, and the text is erased before the cursor begins flashing.
(Here, try the execution of LOAD "AUTO RUN" and check the list.)
If you want to start a certain program after the start of the DISK BASIC, the file
name of that program should be saved on the master disk as "AUTO RUN."
1.2 How to Copy the Disk Basic
Start the DISK BASIC and prepare a new floppy disk for copying.
Execute the directory of DISK BASIC (DIR: refer to page 35) and "FDCOPY".
01 R "F 0 1 : " ICRI ......... Perform the directory of floppy disk drive number
1. The screen becomes as follows when this com-
mand is executed:
OIR "F01:"
01 RECTORY OF F01: XXKB FREE.
OBJ*"OISK BASIS Ul XXX)H(
i:)e.\'\.;'t>~.
-IIIOBJ * "F OCOPY"
I
iOBJ* "TRANS"
r--J
BTX* "AUTO RUN"
I1
Ready
L_III
• Using the
ill
key, move the cursor to the position of the - sign and press the
~
key.
(RUN "FOCOPY")
When "FDCOPY" is executed, the screen becomes as follows.