Troubleshooting - D-Link Air DWL-520 Manual

Troubleshooting

If you encounter any problems during the installation, or to confirm that the
DWL-520 is installed properly, please read the following troubleshooting
section.
Checking the installation of the DWL-520
In Windows 98:
To check that the DWL-520 is installed properly, please do the following:
1.
Go to START>RUN>SETTINGS>CONTROL PANEL>NETWORK.
Choose the Configuration Tab. If you find the D-Link DWL-520 PCI
Adapter, it means the card is installed properly. If you see the Yellow
Question-mark (?), the resources are conflicting. (Please read further
in this section for solutions.)
2.
Right click on My Computer and select Properties.
Device Manager and click on the Network Adapter. You will find the
D-Link DWL-520 PCI Adapter if it is installed successfully. If you see
the Yellow sign, the resources are conflicting. Click on the PCI Card
and then on the PCI Card Service; you can see the status of the PCI
card. If there is a yellow sign either on the adapter or the PCI card,
please check the following.
1.
2.
3.
Check to see if your computer supports 3.3V Card.
Check to see if your computer has a free IRQ. If not,
make an IRQ free by assigning the same IRQ to some
devices, for example COM 1, COM 2 can be assigned the
same IRQ values.
Check that you have inserted the right card and have
installed the proper driver.
-or-
Select the