NEC Express5800 User Manual page 546

G-12 Installing Windows Server 2003
12.
<If the SAS Controller N8103-104A is connected>
Press S.
IMPORTANT:
Insert the Windows Server 2003 OEM-Disk for

EXPRESSBUILDER into the floppy disk drive. If the floppy disk
drive has already contained Windows Server 2003 OEM-Disk for
EXPRESSBUILDER, you do not need to insert the Windows Server
2003 OEM-Disk for EXPRESSBUILDER.
If you have created the OEM-Disk into the Flash FDD, connect the

Flash FDD before you start the system.
The screen of Step 6 is displayed. Press Enter, and go to Step 13.
<If the SAS Controller N8103-104A is not connected>
Press Enter, and go to Step 14.
13.
A list of mass storage devices is displayed.
Select the [LSI Fusion-MPT SAS Driver (Server 2003 32-bit)] and press Enter.
The screen of Step 5 is displayed.
Press Enter, and go to Step 14.
14.
When the following message is shown, press Enter to start "Welcome to Setup".
IMPORTANT:
larger than 2,097,152MB(2TB), you can specify only a value equal to
or less than 2,097,152MB as partition size.
15.
When the installation of Windows Server 2003 has finished, the system reboots
automatically.
– Windows Server 2003 has been installed: Go to the step 19.
– Windows Server 2003 R2 has been installed: Go to the step 16.
If you install Windows Server 2003 on the hard disk