Removing And Installing The Full-Function Monitor Stand - Lenovo ThinkCentre M83z Maintenance Manual

3. If there are rubber cushions, remove them. Then remove the two screws that secure the tilt-only monitor
stand.
Figure 7. Removing the tilt-only monitor stand
4. Remove the tilt-only monitor stand from the computer.
5. To install the tilt-only monitor stand, position the tilt-only monitor stand on the computer so that the two
plastic tabs on the monitor stand align with the corresponding holes in the computer
two screws to secure the tilt-only monitor stand
Figure 8. Installing the tilt-only monitor stand

Removing and installing the full-function monitor stand

To remove and install the full-function monitor stand, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Place a soft, clean towel or cloth on the desk or surface. Hold the sides of your computer and gently lay
it down so that the screen is against the surface and the cover is facing up.
2 . Install the rubber cushions if necessary.
1 . Then, install the
.
Chapter 8 Replacing FRUs
75