Sony XM-1002HX Service Schematics page 2

SERVICE MANUAL
Ver 1.1 2001. 08
AUDIO POWER SPECIFICATIONS (US model)
POWER OUTPUT AND TOTAL HARMONIC DISTORTION
100/50 watts per channel minimum continuous average power into
4 ohms, both channels driven from 20 Hz to 20 kHZ with no more
than 0.04% total harmonic distortion per Car Audio Ad Hoc
Committee standards.
Other Specifications
Circuit system OTL (output transformerless) circuit
Pulse power supply
Inputs RCA pin jacks
High level input connector
Outputs Speaker terminals
Through out pin jacks
Speaker impedance
1* – 8 (stereo)
2* – 8 (when used as a bridging amplifier)
Maximum outputs (HI-CURRENT/HI-VOLTAGE)
120/230 W x 2 (at 4 )
380/580 W (monaural) at 4
Rated outputs (HI-CURRENT/HI-VOLTAGE)
(supply voltage at 14.4 V)
50/100 W x 2 (20 Hz – 20 kHz, 0.04% THD,
at 4 )
70/140 W x 2 (20 Hz – 20 kHz, 0.1% THD,
at 2 )
140/280 W (monaural) (20 Hz – 20 kHz, 0.1% THD,
at 4 )
Frequency response
5 Hz – 50 kHz (
Harmonic distortion
0.005% or less (at lkHz, 4 )
Input level adjustment range
0.2 – 4.0 V (RCA pin jacks)
0.4 – 8.0 V (High level input)
Sony Corporation
9-925-785-12
2001H0400-1 e Vehicle Company
© 2001. 8 Shinagawa Tec Service Manual Production Group
XM-1002HX
SPECIFICATIONS
+0.5
dB)
–3
High-pass filter 50 – 200 Hz, –12 dB/oct
Low-pass filter 50 – 200 Hz, –12 dB/oct
Low boost 0 – 10 dB (40 Hz)
Power requirements 12 V DC car battery (negative ground)
Power supply voltage
10.5 – 16 V
Current drain at rated output : 26 A
(4 HI-VOL TAGE mode)
Remote input : 2 mA
Dimensions Approx. 258 x 50 x 320 mm
l
(10 / x 2 x 12
4
(1/h/p) not incl. projecting parts and controls
Mass Approx. 3.3 kg (7 lb, 4 oz.) not incl. accessories
Supplied accessories
Mounting screws (4),
Terminal cap (1)
Design and specifications are subject to change without notice.
* HI-CURRENT only
STEREO POWER AMPLIFIER
US Model
Canadian Model
AEP Model
UK Model
E Model
5
/ in.)
8
1