To Reset This Player - Kenwood BD-7000 Instruction Manual

Troubleshooting
Network
Problem
Cannot connect to the Internet.
Cannot download BD-LIVE contents.
Other
Problem
The TV operates incorrectly.
The Player heats up during use.
a (On/Standby) indicator will remain
lit.

To Reset this Player

• If this Player receives strong interference from a source such as excessive static electricity,
strong external noise, malfunction of power supply, or voltage caused by lightning during
use or a wrong operation is sent to the Player, errors like the Player not accepting an
operation may occur.
Press and hold a on the Player until the a (On/Standby) indicator disappears.
• When a reset is performed while the power is on, the Player will turn off. Turn the power on again. At this point, it may take a
few moments for the system processing to finish before the Player is ready for use.
• Since all settings including the language setting stored in memory are also reset when a reset has been performed, they must
be set again.
• When the problem persists even after performing a reset, unplug the AC cord and plug it in again. If this does not solve the
problem, contact the nearest service centre approved by Kenwood.
Possible causes and solutions
When the wired Internet connection is made
• Is the LAN cable connected properly?
• Is the wrong cable such as a modular cable used? Connect a LAN cable to the
ETHERNET terminal. (Page 19)
• Is the power for the connected equipment, such as a broadband router or modem
turned on?
• Is the broadband router and/or modem properly connected?
• Is the proper value(s) set in the network setting? Check "Communication Setup".
(Pages 40–41)
• Make sure that this player is connected to the Internet.
• Is the USB memory device properly connected? Check that the USB memory
device is connected to the USB terminal of this Player.
• Check if the BD disc supports BD-LIVE.
• Check the setting for "BD Internet Access". (Page 39)
Possible causes and solutions
• Some TVs with wireless remote control capability may operate incorrectly when
using the remote control of this Player. Use such TVs away from this Player.
• When using this Player, the console cabinet may heat up depending on the usage
environment. This is not a malfunction.
• When the AC cord is removed from the outlet, the a (On/Standby) indicator will
remain lit for a short period. This is normal and is not a malfunction.
a (On/Standby) indicator
a
47