Installation Of Batteries In The Remote Control; Turning The Power On And Off; Button Functions - Hitachi AX-M140 Instruction Manual

Installation of Batteries in the Remote Control

1. Remove the battery compartment cover.
2. Insert two batteries (size AAA) correctly, so that the + and - polarities match the polarity diagrams in
the battery compartment.
* About half a year of normal operation can be expected when using standard batteries.
* When the batteries are exhausted, the remote will not function. Replace both batteries at the same
time with new ones.
* Don't mix old and new batteries.
* Don't mix different types of batteries.
* When the unit is not used for a long period of time, remove the batteries to avoid damage caused by
battery leakage and corrosion.

Turning the Power On and Off

Turning the System On
Press the standby button (STANDBY) to turn the system on from standby mode.
Caution: When turning the system on, the system will continue in the mode it was in when it was turned
off last time.
Turning the System Off
Press the standby button (STANDBY) again to turn the system off (called Standby Mode).
Caution: Be sure to unplug the power cord from the outlet when going away or when the system is not
in use for an extended period of time.

Button Functions

Note: When the unit is in VCR mode, the VCR connected with the unit by the scart cable is for playing
only. If you want to record, the unit must be in standby mode.
In power on mode, press the DVD function button (
Press the open/close button (
disc tray (with the printed side up). Press this button again to close the disc tray, the unit will
read the disc and the disc type will display on the TV screen. The disc should play
automatically.
Press the direction buttons ( , , , ) to move the cursor to illuminate the desired selection.
Press the confirmation button (
In stop mode, press the play/pause button (
When playing disc, press the play/pause button (
press the button again, it will continue to play.
(You can also operate the key "
DVD
) on the unit to open the disc tray then place the disc on the
K
) to confirm the menu selection.
ENTER
) to start playing the disc.
BF
BF
" on the panel of unit.)
BF
- 10 -
) to select DVD function.
) to temporarily stop the playing,