Table of Contents
Advertisement
Battery Installation
The remote control requires one CR2025 lithium battery.
1
Emitter
1.
Remove the cover.
2.
Insert the battery, positive side up. Be sure the retain-
ing clip holds the battery securely.
3.
Reinstall the cover.
Lithium Battery Safety
This product uses a CR2025 Li/MnO2 lithium coin battery.
WARNING: Lithium coin cell batteries pose a serious risk of injury if
ingested. Keep cells out of reach of children. If ingested immediately
contact a physician or the National Poison Center at 202-625-3333.
CAUTION: Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type (CR2025).
CAUTION: Risk of fire and burns. Do not recharge, disassemble,
heat above 100
˚
C (212
children.
Disposal. Dispose of used batteries promptly according to local
recycling or waste regulations.
Controls and Indicators
IR Sensor
POWER Light
Lit when power is on.
3D STATUS Light
Lit during 3D signal processing.
POWER Button
Allows manual override of auto on/off. Press to power
off the Adapter if it powers on when not needed,
3D MODE Button
Allows manual selection of 3D format conversion.
To remove the
battery, press
on the retain-
2
˚
F), or incinerate. Keep battery out of reach of
Adapter
For assistance call 1(800) 332-2119
ing clip.
Remote Control
3
Advertisement
Table of Contents
