Assembly; Unassembled Parts; Tools Required For Assembly - Husqvarna 289580 Owner's Manual

(5) Large Retainer
Springs - 7/16
(2) Smaller Retainer
Springs - 5/16
(1) Anti-Sway Bar
(1) Front Link
Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes.
To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use
the correct tools as necessary to ensure proper tightness.

TOOLS REQUIRED FOR ASSEMBLY

A socket wrench set will make assembly easier. Stan dard
wrench sizes are listed.
(2) 7/16" wrenches
(1) 1/2" wrench
(1) 3/4" wrench
(1) 3/4" socket w/drive ratchet
When right or left hand is mentioned in this man ual, it means
when you are in the operating po si tion (seated be hind the
steer ing wheel).

UNASSEMBLED PARTS

Mower
(1) 3/4 O.D. Washers
(5) 1-3/16 O.D. Washers

Assembly

(2) Rear Lift Link
Assemblies
ASSEMBLY
Utility knife
Tire pressure gauge
Pliers
Mower Front Wheel
(1) Wheel
(1) Shoulder Bolt
(1) Oil Drain Tube
For Future Use
Keys
(2) Keys
TO REMOVE TRACTOR FROM CARTON
UNPACK CARTON
• Remove all accessible loose parts and parts cartons
from carton .
• Cut along dotted lines on all four panels of carton.
Remove end panels and lay side panels flat.
• Remove mower and packing materials.
• Check for any additional loose parts or cartons and
remove.
5
(1) 1-1/4 O.D. Washer
(1) Locknut
3/8-16
Slope Sheet