Installing The Monitor; Installing And Removing The Stands; Using The Wall Mount Or Ceiling Mount - Mitsubishi Electric MDT5525 User Manual

P-2

Installing the monitor

Installing and removing the stands

The stands are available as option.
Refer to the user's manual of the stand for more information.
How to install the stands
1. Turn the monitor off.
2. Insert the option stands in the guide frames on both sides
to the end.
Secure the option stands on both sides fi rmly using the
screws supplied with the option stands.
Screw x 4
(Accessories of
the option stand)
Option stand x 2
(Longer portion comes to the front.)
3. Install the monitor on a fl at and stable surface.
NOTE:
• Install the stands so that their longer portions come to the
front.
How to remove the stands
1. Spread the protective sheet on a fl at surface, such as a
desk.
2. Place the monitor on the protective sheet.
3. Remove the screws to remove the option stands.

Using the wall mount or ceiling mount

Lay the screen face down
Lay the protective sheet on a table, which was wrapped around
the monitor when it was packaged, beneath the screen surface
so as not to scratch the screen surface.
This device cannot be used or installed without the Tabletop
Stand or other mounting accessory. Failure to follow the correct
mounting procedures can result in damage to the equipment or
injury to the user or installer. Product warranty does not cover
damage caused by improper installation.
Failure to follow these recommendations can void your
warranty.
For installation, use M6 iron screws (with a loose-proof spring
washer and having a length 10 mm longer than the thickness of
the mounting bracket) and tighten them securely. MITSUBISHI
ELECTRIC recommends using mounting interface that comply
with TÜV-GS and UL1678 standard in North America.
Guide frame
English-14
624
200
Handles
CAUTION:
For preventing the monitor from falling:
• Install the monitor with metal brackets for wall or
ceiling installation (commercially available) on your own
responsibility. For detailed procedures of installation, refer
to the instructions of the metal brackets.
• To lessen the probability of injury and damage resulting
from fall of the monitor in case of earthquake or other
disaster, be sure to consult the bracket manufacturer for
installation location.
• To lessen the risk of falling of the monitor, thread
commercially available rope through the handles at the
right and left of the monitor and secure the rope to the
wall mount brackets or ceiling mount brackets. Use rope
that can bear a load 6 times the weight of the monitor
(approximately 171 kg).
• Do not sleep where the monitor may topple over or fall in
case of an earthquake or other disaster.
• Use screws having enough strength to support the LCD
display monitor (made of stainless steel etc.).
About the metal bracket:
• Use a VESA-compliant metal bracket.
• Before installation, make sure that the installation surface
has suffi cient strength.
• Use a metal bracket (commercially available) that is strong
enough to hold the monitor.
• Before installation, check the strength and other properties
to ensure the safety.
• Do not block the heat dissipating holes in the monitor with
the metal bracket. See page 13.
• For details of the mounting procedure and the safe
installation procedure, see the user instructions of the metal
bracket (commercially available) to be used.
• Take measures such as using multiple metal brackets,
holding the monitor at several points, and taking measures
to prevent falling or dropping in case of a problem in the
metal bracket or the installation location.
Carry out as necessary
Table
624
200
(mm)
Protective Sheet