Completing The Installation - HP StoreEver 1U User Manual

3. Extend the rack rails past the rear vertical mounting columns and attach the back mounting
plate of each outer rail to the rack using four 10-32 screws in the previously marked holes.
Figure 22 Attaching the back mounting plate

Completing the Installation

1. Ensure all rack safety precautions stated in
2. Extend the left and right rack rails from the front of the rack.
3. Align the rear of the component rails on the enclosure with the front ends of the rack rails,
then slide the unit fully into the rack.
Figure 23 Sliding the unit into the rack
CAUTION:
rails into the rack rails. Tilting the enclosure up or down could damage the rails.
NOTE:
unit. Press the latches on each side 3 and pull the enclosure from the rack 4. See Figure for
the location of the latches.
4. Tighten the front panel thumbscrews.
5. Retract the stabilizing feet of the rack.
6. Plug the data cable from the server into the data connectors on the rear panel of the enclosure.
7. Plug the AC power cord into the power cord connector, then into a grounded outlet.
Be sure to keep the enclosure parallel to the floor when sliding the component
To remove the enclosure from the rack, disconnect the cables from the back of the
"Rack Safety" (page 13)
Installing the 1U Rack-mount Enclosure in a Rack
have been implemented.
17