Related Manuals for Zanussi ZF134UN
Summary of Contents for Zanussi ZF134UN
- Page 1 CONGELATORE FREEZER GEFRIERSCHRANK CONGELATEUR ZF 134 UN LIBRETTO ISTRUZIONI INSTRUCTION BOOKLET GEBRAUCHSANWEISUNG MODE D’EMPLOI 2222 262-06/1...
-
Page 2: General Safety
WARNINGS It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can be acquainted with the functioning of the appliance and the relevant warnings. -
Page 3: Table Of Contents
CONTENTS Installation Positioning Cleaning the interior Location Door reversibility Fitting a decorative door panel Electrical connection Technical specification Control panel Starting up - temperature adjustment Warning light (B) Fast freezing Freezing fresh foods Storage of commercially frozen food Thawing Ice cube trays Defrosting Maintenance Idle periods... -
Page 4: Installation
INSTALLATION If this appliance featuring magnetic door seals is to replace an older appliance having a spring lock Important (latch) on the door or lid, be sure to make that It is essential that the appliance be connected to an spring lock unusable before you discard the old efficient earth tap. -
Page 5: Location
Location Fig. 1 This appliance is designed to be built-in to a space having the dimensions given in Fig. 1. 100-170 D506 The height of the appliance can be altered if required Fig. 2 by means of adjustable feet situated at its base (Fig. -
Page 6: Fitting A Decorative Door Panel
Take the hinge removed from the upper part of the appliance on the opposite side (see Fig. 4), and, using Fig. 4 the screws removed from the lower part, fix it to the base of the appliance itself. Remove and refit the other hinge on the upper part of the appliance on the opposite side. - Page 7 Lay the panel face down (Fig. 6). Position the top bracket on the panel, making sure that there is an Fig. 6 equal distance between it and the sides and that its distance from the top edge is equal to distance (A) less 1 cm.
- Page 8 Check the position again by slackening the screws and pins then, once the best position has been Fig. 10 obtained, fully tighten all the fixings. Cover the visible part of the top bracket on the panel with plastic cover (D), inserting it in the locations provided in the bracket.
-
Page 9: Electrical Connection
If the appliance has been fitted into a space 870 mm high and the maximum height of the base plate is 150 Fig. 14 mm, fit the front cover plate as described in Fig. 13. If the base plate is between 150 and 185 mm high, cut it as shown in Fig. -
Page 10: Use
The freezer is marked with the symbol, which indicates that it is suitable for freezing fresh food and for long-term storage of frozen and deep-frozen foods. Control panel A - NORMAL-SUPER switch with yellow indicator light B - Warning light C - Thermostat knob for temperature adjustment D - On-Off switch with green indicator light Starting up - temperature... -
Page 11: Freezing Fresh Foods
Freezing fresh foods It is a good idea to mark the packs or the special cards (if supplied) with the date on which freezing started To fast-freeze foods when the appliance has not been so that you can keep a check on storage periods. in use, switch on the freezer and let it run on the fast- If accidental thawing occurs –... -
Page 12: Ice Cube Trays
Ice cube trays The appliance includes one or more trays for producing ice cubes. These trays should be filled with drinking water and repositioned inside the compartment. Do not use metal tools to remove the trays. Defrosting The frost inside the appliance must be removed whenever it reaches a thickness of 4 mm, using the special scraper. -
Page 13: Maintenance
MAINTENANCE Idle periods During periods when the appliance is not used, you should take the following precautions: remove the plug from the wall socket; remove all food from the appliance; defrost and clean the interior and all accessories; leave the door slightly open, thus letting air circulate and preventing the formation of mould and unpleasant smells.