Starting Up The Recorder - Toshiba D-R150SB Owner's Manual

Basic Setup

Starting up the recorder

After all the necessary connections,
• Turn on the equipment connected to the
recorder.
• Select the corresponding video input on
your TV.
Perform these selections whenever you operate
the recorder.
Turning the power on
Press ON/STANDBY button from the remote control or
on the front panel of the recorder.
ON/STANDBY button
OPEN/CLOSE ON/STANDBY
1 2 3
4 5 6
7 8 9
+ 10
0
CLEAR
TIME SLIP INPUT SEL.
DVD TV
TV VOL CH
T SEARCH PROGRESSIVE
When the power turns on, the display of the front
panel shows "ON".
After a few seconds, a startup screen appears.
The following icon will appear on the top right corner
of the screen. The icon will continue flashing
momentarily.
e.g.
22
04_D-R150SB(E)_inst_21-33
ON/STANDBY button
Loading
22
While the icon is flashing, the recorder is checking
the status and reading data of the DVD drive for
startup. If the DVD drive does not contain a disc,
the recorder consumes less time to startup,
because it does not need to read data from the
DVD drive.
While the "Loading" icon is flashing, the recorder
cannot respond to any operations. Operate after the
icon has disappeared.
Note
When the recorder is turned on for the first time, the
following menu may be displayed after the "Loading" icon
has disappeared. See "A: Initial settings" (
e.g.
Initial settings
Auto
Time & date setting
Auto
Channel setting
Input signal PAL
Video
AV1 output
AV2 input Video
1
Clock set position
On
Just clock
Turning the power off
Press ON/STANDBY button from the remote control or
on the front panel of the recoder.
The "Unloading" icon appears on the right corner of
the top of the screen, and the display of the front panel
shows "OFF". Then the power turns off.
Note
• If the recorder freezes for about 15 minutes and will not
respond to any buttons, holding down ON/STANDBY
button on the front panel for about 10 seconds can force
the recorder to turn off. However, this is an emergency
measure, which contains a risk of damage to data or discs.
Avoid casual use of this measure.
05.7.13, 0:23 AM
page 24).
SETUP