The polystyrene moulded parts have been foamed without any If the dishwasher is to be installed CFCs. in a high-sided unit, ensure that the unit The polyethylene film (PE) consists is attached properly and also at the rear.
Engaging the child lock must be placed in the baskets either flat or with the points downwards. Opening the door with the child lock Use the dishwasher only in the engaged household and only for its designed Disengaging the child lock purpose, i.e.
“Check water supply” indicator You will need to purchase the Programme buttons following before using the dishwasher for the first time: * not included with all models Always keep the fascia clean and free – special salt for use in dishwashers of grease.
Press and hold the B programme button, and set the main switch In order to rinse dishes and glasses ON, before releasing the programme satisfactorily, the dishwasher requires soft button again. water, i.e. containing little or no lime, The indicator lamp for the B button...
Unscrew the lid on the salt container The LOW SALT indicator on the front Before you use the dishwasher for the first panel will light up initially but will extinguish time, pour approx. 1 litre of water into the again after a short period when the salt salt container.
(on applicable models) or dispenser has not illuminated, there is sufficient rinse-aid in the dishwasher. Close the lid, ensuring that you hear it snap closed. Use only rinse aid for domestic dishwashers. Spilt rinse aid may result in excessive foam formation in the next rinse cycle.
You can switch the rinse-aid indicator The following should not be on or off. This function can be changed as cleaned in the dishwasher: follows: Close the door. Wooden cutlery and utensils – these will leach out and become unsightly;...
Very small items should not be washed in as possible after the programme has the dishwasher as they could easily fall out ended. of the baskets. Washing contents of UPPER Removing the dishes...
Cups and glasses Cutlery Upper basket Cutlery should be placed in the dishwasher always unsorted and with the eating surface pointing downwards. The spray jet is then better able to reach the individual parts. To prevent injuries, place long, pointed accessories and knives on the étagère...
Small accessories holder* Adjusting position of basket * * some models * not on all models Light-weight plastic accessories, e.g. cups, lids, etc. can be held securely in the small accessories holder. Ø max. 20/*25cm Ø max. 20/*25cm Ø max. Ø...
Page 14
Top basket with side levers (Rackmatic) Pull out the top basket. To raise the basket, take hold of the basket on the upper edge and pull upwards. Before you re-insert the basket, ensure To lower the basket, press in that it is at the same height on both succession the two levers on the left sides.
If you have any further questions, we recommend that you contact the customer advice departments of the various Note detergent manufacturers. Never operate the dishwasher without the top basket or baking sheet spray head!
Please observe the manufacturer’s determine where the tablets should be instructions printed on the detergent placed inside the dishwasher (e.g. in packaging when determining the cutlery basket, detergent compartment, correct dosage. etc.). Make sure that the lid on the detergent...
auto 3in1 Note The use of so-called combined detergent Optimum rinsing and drying results can be products may make the use of rinse aid obtained by using standard detergents in and/or salt unnecessary. conjunction with separate application of There are currently several types of salt and rinse aid.
Page 18
Switching the salt refill indicator / water softening system off and on Close the door. Hold down the programme button B and switch on the main switch then release the buttons. The illuminated button B and the factory-set value on the digital display flash.
Washing dishes Switching the dishwasher ON Turn on the tap. Set main switch to ON. Reduce costs! Indicators light up according to the last If only a small number of programme that was selected. dishes have been loaded into This same programme will run again if...
The numerical display shows Close the door. The programme continues for approx. 1 min. When it has ended, set the main switch to OFF. Close the detergent compartment To restart the dishwasher, set main switch to ON again and select desired programme.
This saves time and prevents problems. clog up the filters. Therefore you should occasionally have The filter system consists of a filter a careful look inside your dishwasher. cylinder, a flat fine filter and, depending on Overall condition the model, a microfilter (*).
Reassembly: Spray arms Insert the filter system and screw down Lime and remnants of food in the washing with the filter cylinder. water can block the nozzles in the spray arms and the arm mountings . Inspect the nozzles in the spray arms for blocked holes due to remnants of food.
The water is no longer pumped normal daily usage yourself, without out of the dishwasher and it can be seen having to call out a service engineer. Not covering the filter. only does this save costs, but it also...
... when the appliance “Check water supply” display lights up. is switched on Tap turned off. The appliance does not start. Water supply interrupted. The mains fuse has tripped. Filter in the water supply blocked. The appliance plug has not been Supply hose kinked.
Page 26
Remnants of food are stuck to the Amount of rinse-aid was set too dishes, cutlery, etc. low. Dishwasher was not loaded Items were removed from properly. Jets of water could not dishwasher too soon. reach all parts of the dishes, etc.
Customer Service Information Please call your local service agent, if you Notes on comparison tests are not able to resolve any problem You will find details of the conditions for yourself. The name of your nearest service the comparison tests on the additional agent is shown in the Customer Service ”Notes on comparison tests”...
Installation Fresh water connection Using the enclosed parts, connect the The dishwasher must be connected by fresh water connection to the tap a qualified technician to ensure correct according to the installation instructions. operation. The specifications for supply, Ensure that the fresh water connection is drainage and connected load must fulfil not kinked, crushed or twisted.
If fitted, remove the base panel. Pull out the appliance, carefully pulling the hose behind. Transporting the dishwasher Drain water from the dishwasher. Secure all loose parts. The appliance should only be transported in an upright position. If the appliance is not kept upright...
Waste disposal The polyethylene film (PE) consists partly of secondary raw materials. Disposal The wooden frames (if fitted) are made of untreated residual wood. Old appliances are not worthless rubbish. The hoops (if fitted) consist Valuable raw materials can be reclaimed of polypropylene (PP).
Page 32
Siemens–Electrogeräte GmbH Carl–Wery–Straße 34 81739 München To contact us directly, use the tel. no or fax no. in the enclosed customer service list. 129181 9000 en (8510) 1G0275 630G...