Before Operation; Display Modes - Yamaha EQ-1100 Owner's Manual

Changing the battery (See Fig. 9.)
© Remove the cover.
(2) Insert battery (size "AA", R06), or equivalent making
sure that the positive and negative poles are facing in
the right direction.
(3) After the battery has been changed snap the lid back
on.
If the battery runs down, the sensitivity of the microphone
will decrease. Change the battery as soon as it starts to
run down.
Battery Cautions
If the battery is replaced incorrectly, dangerous leakage
or corrosion may result. Be especially careful of the
following points:
When replaceing:
• Insert the battery with correct (+) and (-) indications
correctly into the battery compartment.
Rechargeable batteries:
• There are two types of batteries; rechargeable and
nonrechargeable. Check the cautions label on the
battery before use.
To avoid accidents:
• Never disassemble, heat or throw a battery into a fire.
When disposing, deal with batteries as inflammable
matter.
• Do not short the (+) and (-) terminals directly.
When battery leakage occurs:
• Wipe off the liquid in the battery compartment and
replace the battery with new one.

BEFORE OPERATION

■ DISPLAY MODES

The display modes include the spectrum mode and
equalizer level mode.
• SPECTRUM DISPLAY (LEFT), (RIGHT), (LEFT +
RIGHT)
• EQUALIZER LEVEL DISPLAY (LEFT) OR (RIGHT)
• EQUALIZER LEVEL DISPLAY (LEFT RIGHT)
"sections where the left and
■ AUTO-LEVELING FUNCTION
If the spectrum level becomes too high or too low due to
the influence of the input signal level, the auto-leveling
function adjusts the spectrum display level in three steps
(0 dB, -6 dB, -12 dB) so that the spectrum is always at the
center of the display.
• WHEN INPUT LEVEL IS HIGH
• WHEN INPUT LEVEL IS LOW
High-brightness display in
right levels are the same.