Partition/Partition Size - Mitsubishi Electric DX-TL2500E Installation And Operation Manual

PARTITION/PARTITION SIZE

PARTITION mode only uses the internal HDD, and pe-
ripheral recording device HDD's. PARTITION mode des-
ignates the area inside the HDD that is specified as each
HDD's sub-device capacity for Alarm recording. This
independent partition inside the HDD allows to keep the
data of alarm recording.
1. Turn ON the MAIN switch on the rear of the unit, and wait
until the ACCESS indicator goes off. Hold down the REC/STOP
button, and press the POWER button on the front of the unit.
• The <INITIALIZATION> screen is displayed.
2. Select "HDD SETTING" by turning the JOG dial, display
"PARTITION", and turn the SHUTTLE ring clockwise.
• The "PARTITION SIZE" setting appears on the
<INITIALIZATION> screen.
<INITIALIZATION>
ID4•ID5
>>HDD SETTING
PARTITION SIZE
BOOT UP DELAY
POWER OFF
INITIALIZATION
ALL DATA WILL BE ERASED
WHEN PROCEED INITIALIZATION
3. Display the desired device capacity, and turn the SHUTTLE
ring clockwise.
• The setting is made.
• Setting of "PARTITION SIZE" ( default : 10% )
10%, 20%, 30%, 40%, 50%, 60%, 70%, 80%, 90%
The normal recording area is referred to as "MAIN",
and the alarm recording area (PARTITION area) is re-
ferred to as "SUB".
The storage area in MAIN HDD set in "PARTITION"
10
is displayed with the percentage(%) and the record-
11
able time of that storage area is displayed in "<ESTD
12
13
REC>".
14
15
16
1.563P STD
PRE ALARM REC
<ESTD REC>
4. Select "INITIALIZATION" by turning the JOG dial, and turn
the SHUTTLE ring clockwise.
• The setting is made, and initialization commences.
Initialization deletes all data in the HDD.
•••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••• Operations
ARCHIVE•COPY
PARTITION
10%
30S
1.563P STD
( S ) S
SHUTTLE<<:BACK
%
D H M
Points to be aware of regarding PARTITION
mode
• Either "MAIN" or "SUB" can be selected for ar-
chive/copy.
• Playback, search, information display, REMAIN
HDD, MODE OUT, CALL OUT, and data delete
functions are performed independently for "MAIN"
and "SUB".
• When "HDD REPEAT REC SUB" is set to "OFF",
and all memory in SUB HDD is used, the record-
ing stops. Switch "HDD REPEAT REC SUB" to
"ON" or delete data in SUB HDD to restart record-
ing.
• Archive data is transmitted in 1MB units. The
archive of up to 1MB of the latest data may be
delayed. Beware when changing the archive de-
vice.
• When at the time of "ALARM CH" use an alarm
signal enters to a camera number not set for nor-
mal recording, pre-alarm recording may not be
performed in some cases.
79