1. Manuals
  2. Brands
  3. Miele Manuals
  4. Ventilation Hood
  5. DA 403 EXT
  6. Operating and installation instructions

Miele DA 400 EXT Operating And Installation Instructions

Hide thumbs Also See for DA 400 EXT:
Table of Contents

Advertisement

Quick Links

Download this manual See also: Operation & Installation Manual
Operating and installation instructions
Cooker hoods
DA 400, DA 400 EXT
DA 403, DA 403 EXT
GWOZHr
To avoid the risk of accidents
or damage to the appliance
it is
to read these
operating instructions before it is
installed or used for the first time.
M.-Nr. 06 417 700

Advertisement

Table of Contents
loading

Related Manuals for Miele DA 400 EXT

Summary of Contents for Miele DA 400 EXT

  • Page 1 Operating and installation instructions Cooker hoods DA 400, DA 400 EXT DA 403, DA 403 EXT GWOZHr To avoid the risk of accidents or damage to the appliance it is to read these operating instructions before it is installed or used for the first time.

  • Page 2: Table Of Contents

    ......... . 3 .
  • Page 3 Electrical and electronic appliances often contain materials which, if The transport and protective packing handled or disposed of incorrectly, has been selected from materials which could be potentially hazardous to are environmentally friendly for human health and to the environment. disposal, and can normally be They are, however, essential for the recycled.
  • Page 4 This appliance complies with all Before connecting the appliance to relevant legal safety requirements. the mains supply, make sure that Inappropriate use can, however, the voltage and frequency details given lead to personal injury and damage on the data plate correspond with the to property.
  • Page 5 Never These models may only be combined leave an open grill unattended when with a Miele external motor. grilling. Overheated oil and fat can ignite and could set the cooker hood on In countries where there are areas fire.
  • Page 6 These can be obtained from the Miele and young children. Danger of Spare Parts department or from suffocation! Dispose or recycle all builders' merchants.
  • Page 7 In order to ensure safe operation, and to prevent gases given off by the heating appliances from being drawn back into the room when the extractor and the heater are in operation simultaneously, an underpressure in the room of 0.04 mbar (4 pa) is the maximum permissible.
  • Page 8 The Miele DSM 400 control module can be used to connect other components to the cooker hood (see "Operation with a DSM 400 control module").
  • Page 9 The cooker hood works with (available as an optional extra with a conversion kit and charcoal filter: see "Technical Data") The air is drawn in and cleaned first by The air is drawn in, cleaned by the the grease filters and then by a grease filters and directed outside.
  • Page 11 The indicator lamp for the grease filter touch control lights up when the grease filters need to be cleaned. The touch control is used: – to reset the operating hours counter (special accessory for recirculation after cleaning the grease filters (see mode) "Cleaning and care").

  • Page 12: Intensive Setting

    The indicator lamp will come on. If the cooker hood has been connected to a window contact switch via the Miele Control module ^ Press the run-on option touch control DSM 400 then the fan cannot be for approx. 10 seconds. The first fan switched on if the window is shut.

  • Page 13: Run-On Option

    It is advisable to run the fan for a few minutes after cooking is finished to neutralise any lingering odours in the The indicator lamps for fan power levels air, whether you are using air extraction "I" and "IV" will flash if the automatic or recirculation mode.
  • Page 14 The hob lighting can be switched on Should the cooker hood be left on, the and off independently of the fan. fan will switch off automatically after 10 hours. The lighting will remain on. ^ Briefly press the lighting touch control ^ Pressing the On/Off touch control will to switch on the hob lighting.

  • Page 15: Filter Operating Hours Counter

    ^ Press the charcoal filter touch control for about 3 seconds. The number of hours the appliance has been in operation is stored in memory. The indicator lamp for the touch control will go out. To check the percentage of time set The indicator lamp for the grease filter already used: touch control will come on after 30...
  • Page 16 The indicator lamp for the grease filter touch control and one of the " / " You can set the operating hours touch control lamps will flash. counter to suit the type of cooking you – Select a short time if you roast or fry a lot.
  • Page 17 (with recirculation mode) The charcoal filter is needed for The " / " control lamps show the time recirculation mode. which has been set: 1st lamp from the left = 120 hours The cooker hood is set at the factory for 2nd lamp from the left = 180 hours extraction mode.
  • Page 18 (This infomation does not apply to the controls). Stainless steel surfaces can be cleaned using the Miele E-cloth, or with a The surfaces and controls are proprietary non-abrasive cleaning susceptible to scratches and agent designed specifically for use on abrasions.
  • Page 19 The controls may suffer discolouration or damage if soiling is left on them for too long. Remove soiling straight away. Observe the General notes on cleaning earlier in this section. Do not use stainless steel cleaning agents on the controls. ^ To take out the grease filters, release the locking clip on the filter, lower the filter 45°, unhook it at the back and...

  • Page 20: Housing

    New filters can be purchased from are facing down towards the hob. your Miele dealer or from the Miele Spare Parts Department. See back cover for contact details, and "Technical data" for the model number of the filter.
  • Page 21 Always replace the charcoal filter imme- diately if – the indicator lamp for the charcoal filter touch control lights up, – if it is no longer effective in absorbing kitchen odours. It should, however, be replaced at least every 6 months. Used charcoal filters can be disposed of with the normal household waste.
  • Page 22 Before any cleaning or maintenance work, the cooker hood must be disconnected from the mains supply. Ensure that, depending on connection: – it is switched off at the wall socket and the plug is removed, – the fuse is withdrawn from the ^ To access the halogen lamp, first fused spur connection unit, or remove the lamp cover a.
  • Page 23 In the event of a fault which you cannot correct yourself, or if the appliance is under guarantee, please contact: – Your Miele Dealer – The Service Department (see back cover for address). When contacting your Dealer or the Service Department, please quote the model and serial number of your appliance.
  • Page 24 1) Alternative positions for feeding through the mains cable 2) For ...EXT models only: cut-out for feeding the connection cable through to an external fan, min. 65 x 30 mm 3) Height range for appliance in extraction mode 4) Height range for appliance in recirculation mode 5) Ventilation grille position for recirculation...
  • Page 25 - 550 mm above electric cookers/hobs - 650 mm above gas cookers/hobs - 650 mm above an open grill from the Miele range. See the Warning and Safety instructions for further information. A distance of 700 mm above the hob may be preferable to give more working space.
  • Page 26 Before installation, it is important to read the information given on the following pages as well as the "Appliance dimensions" and the "Warning and Safety instructions" at with the beginning of this booklet. This is particularly crucial when using the cooker hood at the same to secure the cover plate to the ceiling time as a heating appliance that relies on oxygen from the same...
  • Page 27 For extra safety it is advisable to install All electrical work should be a residual current device (RCD) with a undertaken by a suitably qualified trip current of 30 mA. and competent person in strict accordance with national and local safety regulations.
  • Page 28 The Miele DSM 400 Control module can If the control module is be used to combine the cooker hood disconnected in order to operate the with other components. cooker hood without the window It enables the following: contact switch (e.g. after moving...

  • Page 29: Installation Instructions

    The control module can be used to switch on the cooker hood lighting and also to dim it via a light switch in the house. The control module is fitted in the tower after the cover plate has been unscrewed from the ceiling. The control module is supplied with its own detailed operating and installation instructions.
  • Page 30 – Where ducting is horizontal, it must Important: To avoid the danger of be laid to slope away at at least 1 cm toxic fumes, please observe the per metre. Warning and Safety instructions. This is to ensure that condensate This is especially crucial when using cannot drain back into the cooker the cooker hood at the same time as...

  • Page 31: Condensate Trap

    If the exhaust ducting is to run through (optional accessory for ...EXT models rooms, ceiling space etc. where there only) may be great variations in temperature between the different areas, the problem of condensation will need to be addressed. The exhaust ducting will need to be suitably insulated.
  • Page 32 DA 400....38.4 kg DA 400 EXT ....35.2 kg DA 403.
  • Page 36 Alteration rights reserved / 4304 M.-Nr. 06 417 700 / 00 en - GB...

Table of Contents