Panasonic NV-GS320 Operating Instructions Manual page 97

ª
Install a button-type battery
Install the button-type battery supplied in the
remote control before using it.
1
While pressing the stopper 1, pull out the
battery holder.
2
Set the button-type battery with its (i) mark
facing upward and get the battery holder
back in place.
CAUTION
Danger of explosion if battery is
incorrectly replaced. Replace only with
the same or equivalent type
recommended by the manufacturer.
Dispose of used batteries according to
the manufacturer's instructions.
Warning
Risk of fire, explosion and burns. Do not
recharge, disassemble, heat above
60 xC or incinerate.
Warning
Keep the Button-Type battery out of the
reach of children. Never put Button-
Type battery in mouth. If swallowed call
your doctor.
Before using
1
ª
Remote control usable range
≥The distance between the remote control and
the camera: Within approx. 5 m
Angle: Approx. 10o up and 15o down, left, and
right
ª
Selecting the remote control mode
If 2 cameras are used simultaneously, set the
mode for one pair of movie camera and remote
control to [VCR1] and that of the other pair to
[VCR2]. This will prevent interference between
the 2 pairs. (The default setting is [VCR1]. When
the button-type battery is replaced, the setting will
revert to the default [VCR1].)
1
Setting on the camera:
Set [SETUP] >> [REMOTE] >> [VCR1] or
[VCR2].
2
Setting on the remote control:
2
[VCR1]:
Press [D] and [∫] simultaneously. 1
[VCR2]:
Press [E] and [∫] simultaneously. 2
1
97
VQT1A48