Table of Contents
Advertisement
Available languages
Available languages
General Information and Instructions
Your new Kenmore Patio Grill has been designed and
manufactured to high quality standards. It will provide
you with many years of enjoyment with a minimal
amount of maintenance. Please keep in mind the
following FOR YOUR SAFETY.
OPERATION
1.
Your gas grill requires reasonable care during
operation. It will be hot during cooking and
cleaning. You should never leave the grill
unattended or move the grill when in use.
2.
Children should never use your gas grill. Keep
younger children and pets away when in use.
3.
Only use your gas grill outside in a
well-ventilated area. Never use indoor in any
building, garage, shed, or under any type of
flammable canopy or overhang.
4.
Ensure your grill is on level ground before use.
5.
Turn all gas valves off should the burner go out
when cooking. Open the lid and wait 5 minutes
before relighting.
6.
Do not lean over the grill or touch the edges of
the firebox or lid when in use.
7.
Turn the burners off, close the lid, and shut off
the LP cylinder should a grease fire occur.
8.
Do not obstruct the flow of combustion and
ventilation air to this grill.
9.
Keep the ventilation openings of the cylinder
enclosure free and clear from debris.
10. Keep the outdoor cooking gas appliance area
clear and free from combustible materials,
gasoline, and other flammable vapors and
liquids.
11. Do not put a grill cover or other flammable
material in the storage area of this grill.
12. Do not use charcoal briquettes, lava rock, or any
type of ceramic product in this grill.
LP Gas and Cylinder Information
Your new gas grill operates on LP (Liquefied Petroleum)
gas. LP gas is odorless, colorless, and non-toxic when
produced. You can smell LP gas as it has been given an
odor similar to rotten cabbage for your safety.
Your grill uses the newest and safest LP Gas
Cylinder. It must meet the following
requirements:
1. 20-pound (9.1kg) propane cylinder.
2. Measurements: 12-1/2 in. (317mm) in diameter
and 18-1/2 in. (472mm) in height.
In addition, the LP Gas Cylinder to be used must
be or have:
•
Constructed and marked with U.S. Department of
Transportation (D.O.T.) for the US or
CAN/CSA-B339, Cylinders, Spheres and Tubes for
Transportation of Dangerous Goods; and
Commission, for Canada.
•
A listed overfilling prevention device (OPD).
A triangular hand wheel identifies this feature.
Only use LP gas cylinders with this type of
valve.
•
Type 1 quick connect valve for cylinder connection.
•
A safety release valve.
•
A means for vapor withdrawal.
•
A collar to protect the tank valve.
Do not attempt to use a cylinder with
any other type of connection device.
LP CYLINDER FILLING AND EXCHANGE
Some areas of the country only allow you to exchange
your empty cylinder for a replacement that is already
full. Other areas allow you to refill your cylinder. If
you are in an area where you can refill your cylinder:
•
Use only a licensed dealer.
•
The dealer must first purge a new cylinder before
filling.
•
Never fill a cylinder more than 80% full by weight.
Volume will vary by temperature. An empty
cylinder weighs approximately 18 pounds
18
Triangular Hand Wheel
Advertisement
Table of Contents
