English - Kenwood CG100 series User Manual

English

before using your Kenwood key
appliance
G power unit
Read these instructions carefully and
lid with operating button
retain for future reference.
G blade assembly (fixed)
Remove all packaging and any
cord stowage
labels.
safety to grind beans
1 Place up to 50g/2oz of coffee beans
G Never use a damaged appliance.
into the coffee mill. The lid can be
Get it checked or repaired: see
used as an approximate measure
'service'.
G Never put the appliance in water or 2 Place the lid on the unit so that the
button is positioned above the
let the cord or plug get wet – you
Kenwood name. It will not fit in any
could get an electric shock.
other position but will drop easily
G Unplug;
into place when correctly located.
G G before cleaning
G G after use 3 Connect to the power supply and
switch on the appliance by depress-
G Avoid contact with moving parts.
ing the button in a continuous oper-
G The motor should not be allowed to
ation or a series of pulses until the
run for longer than 1 minute in any 5
desired consistency is achieved
minute period.
G
This will vary according to the quan-
Do not let the cord hang over the
edge of the worksurface or touch tity of coffee ground and the degree
of roasting.
hot surfaces.
G 4 Lift the lid to remove.
Do not let infirm people use the
5 Use the ground coffee as required.
appliance without supervision.
G
Do not let children use or play with
Important:
the appliance.
If the lid is removed to check the
G
Only use the appliance for its intend-
consistency of the coffee grounds,
ed domestic use. Kenwood will not
always ensure that the inner rim is
accept any liability if the appliance is
free of coffee particles. This can be
subject to improper use, or failure to
carried out by shaking the grounds
comply with these instructions.
into the centre
before plugging in may prevent the appliance from
operating. If this is the case, remove
G Make sure your electricity supply is
the lid, clear the grounds from the
the same as the one shown on the
rim as above, replace the lid.
underside of your machine.
G Always ensure that the blades have
This machine complies with
stopped revolving before removing
European Economic Community
Directive 89/336/EEC. the lid of the coffee mill.
before using for the first time
1 Wash the parts: see 'care and clean-
ing'.
2 Wind excess cord around the motor
base and secure in the slot provided
.
2
.
.
. Failure to do this