LG LCG3691ST Installation Instructions Manual

Gas cooktop
Hide thumbs Also See for LCG3691ST:

Advertisement

GAS C00KTOP
INSTALLATIONINSTRUCTIONS
Please read this guide thoroughly
before installation.
To contact
LG Electronics,
24 hours a day,
7 days a week:
1-800-243-0000
(U.S.A.)
1-888-542-2623
(Canada)
Or visit us on the Web at:
us.lge.com
(U.S.A.)
ca.lge.com
(Canada)
f
BEFORE YOU BEGIN
Read these
instructions
completely
and carefully.
installation of this cooktop must conform with local
codes,
or in the absence of local codes, with the
National Fuel Gas Code, ANSi Z223.1/NFPA.54,
latest edition, in Canada, installation
must
conform
with the current Natural Gas installation
Code, CAN/CGAB149.1
or the current Propane
installation
Code, CAN/CGA-B149.2,
and with
local codes where applicable.
This cooktop
has
been design-certified
by CSA international
according
to ANSi Z21.1, latest edition and
Canadian
Gas Association
according
to
CAN/CGA-1.1
latest edition.
As with any appliance
using gas and generating
heat, there are certain safety precautions
you
should follow. You will find these precautions
in
the important
Safety information
section in your
User's Guide. Read them carefully.
• IMPORTANT
- save these instructions
for local electrical
inspector's
use.
° IMPORTANT
- Observe all governing
codes and ordinances.
Note to installer:
Leave these instructions
with
the appliance
after installation
is completed.
Note to Consumer:
Keep the User's Guide and
installation
instructions
for future reference.
NOTE: This appliance
must be properly
grounded.
The electrical
diagram is in an envelope
attached
to the back of the cooktop.
Skill level-
installation
of this appliance
requires basic mechanical
skills.
Proper installation
is the responsibility
of the
installer.
Product failure due to improper
installation
is
not covered under the Warranty.
Remove all tape and packaging.
Make sure the burners are properly seated
and level.
Take the accessory
pack off of the cooktop.
Check to be sure that no cooktop
parts have
come loose during shipping.
,J
P/No.: MFL62725501

Advertisement

Table of Contents
loading

Summary of Contents for LG LCG3691ST

  • Page 1 GAS C00KTOP To contact LG Electronics, 24 hours a day, 7 days a week: 1-800-243-0000 (U.S.A.) INSTALLATIONINSTRUCTIONS 1-888-542-2623 (Canada) Or visit us on the Web at: Please read this guide thoroughly before installation. us.lge.com (U.S.A.) ca.lge.com (Canada) BEFORE YOU BEGIN...
  • Page 2: For Your Safety

    INSTALLATION INSTRUCTIONS READ ALL INSTRUCTIONS BEFORE INSTALLATION IN THE COMMONWEALTH OF MASSACHUSETTS • This product must be installed by a licensed • A flexible gas connector, when used, must not plumber or gas fitter. exceed 3 feet in length. • When using ball type gas shut-off valves, they shall be the T-handle type.
  • Page 3: Installation Safety Instructions

    INSTALLATION INSTRUCTIONS INSTALLATION SAFETY INSTRUCTIONS BEFORE YOU BEGIN Remove all tape and packing materials before using the cooktop. Dispose all plastic bags after unpacking the cooktop. Never allow children to play with packing materials. IMPORTANT SAFETY INSTRUCTIONS Read these instructions completely and carefully.
  • Page 4 INSTALLATION INSTRUCTIONS NSTALLATION SAFETY INSTRUCTIONS (continued) The ventilating hood must be constructed of sheet • The vertical distance from the plane of the cooking metal not less than 0.0122" thick. Install above the surface to the bottom of adjacent overhead cabinets cooktop with a clearance of not less than 1/4"...
  • Page 5: Dimensions And Clearances

    INSTALLATION INSTRUCTIONS DIMENSIONS AND CLEARANCES Provide enough clearances between the cooktop The cooktop may be placed with 2 3/4" clearance to and adjacent combustible surfaces. These dimensions the back wall. must be met for safe use of your cooktop. The location of the electrical outlet and pipe opening may be adjusted to meet specific requirements.
  • Page 6: Installing The Cooktop Unit

    INSTALLATION INSTRUCTIONS INSTALLING THE COOKTOP UNIT 1. LOCATE ELECTRICAL OUTLET 4 INSTALL THE RETAINER BRACKETS AND GAS SHUT-OFF VALVE Install the retainer brackets to the bottom BENEATH CABINET of the cooktop unit, then snug the bolts 'Ji, ! against the bottom of the countertop NEVER RE-USE shown OLD FLEX...
  • Page 7: Provide Adequate Gas Supply

    INSTALLATION INSTRUCTIONS 1. PROVIDE ADEQUATE GAS SUPPLY This cooktop is designed to operate at a pressure For LP gas, the pressure supplied must be between 10" and 13" of water column. of 5" of water column on natural gas or 10" of water column on LP, propan or butane gas.
  • Page 8 INSTALLATION INSTRUCTIONS FLEXIBLE CONNECTOR HOOKUP Pressure regulat°r -'-'I_ Adapter ql---_ Adapter Installer: Inform the consumer of the _F_I11 _-- shut-off location of the gas 1/2" or 3/4" _ L,-_ - valve shut-off valve. Gas pipe...
  • Page 9: Electrical Connections

    INSTALLATION INSTRUCTIONS 3. ELECTRICAL CONNECTIONS ELECTRICAL REQUIREMENTS 120 Volt, 60 Hertz, properly grounded dedicated The power cord of this appliance should be equipped circuit protected by a 15 A or 20 A circuit with a three-prong (grounding) plug which mates with breaker or time delay fuse.
  • Page 10: Seal The Openings

    INSTALLATION INSTRUCTIONS 3. ELECTRICAL CONNECTIO (continued) The installation of appliances designed for mobile CAUTION home installation should conform with the Manufactured Home Construction and Safety Standard, Title 24 The customer should have the circuit checked by CFR, Part 3280 (formerly the Federal Standard for a qualified technician to make sure the receptacle Mobile Home Construction and Safety, Title 24, HUD,...
  • Page 11: Assemble The Surface Burners

    INSTALLATION INSTRUCTIONS 5. ASSEMBLE THE SURFACE BURNERS Make sure the hole in the burner head is positioned CAUTION over the electrode. DO NOT operate the burners without all parts in place. Hole Piece the burner caps and heads on the cooktop. Make sure that the caps and heads are placed in the Electrode correct locations.
  • Page 12 INSTALLATION INSTRUCTIONS ADJUST THE SURFACE BURNER LOW FLAME (SIMMER) SETTING 7. Position center burner head, center burner cap, For all surface burners except for the center center grate, center knob. burner 8. Connect power to appliance. 1. Light all surface burners except for the center 9.
  • Page 13: Converting To Lp Gas

    INSTALLATION INSTRUCTIONS WHEN ALL HOOKUPS ARE COMPLETE Make sure all controls are left in the off position. Make sure the flow of combustion and ventilation air to the cooktop is unobstructed. CONVERTING TO LP GAS (OR CONVERTING BACK TO NATURAL GAS FROM LP) This cooktop leaves the factory set for use with The conversion...
  • Page 14 Memo...
  • Page 15 Electronics Inc. Printed In Korea Impreso en Korea Imprim6 en Cor6e...

This manual is also suitable for:

Lcg3091st

Table of Contents