Advertisement
Event
Enter
Request To Exit
Restoral Report
RF Low Battery
RF Batt Restor
RTE Deny
Intrlok
RTE Deny
Secured
REX Deny
Intrlok
REX Deny
Secured
S: Alarm
S: Closing
S: Fire
Supervision
S: Opening
S: Perim Delay
S: Perim
Instant
S: Supervision
S: Trouble
SDI Failure
SDI Restoral
Sensor Reset
Service End
Service Start
Sked Bypass
Sked Changed
Sked Executed
Status report
Supervision
Swinger Bypass
Test Report
Time Changed
© 2002 Bosch Security Systems
Description
A Request To Exit device for an access door has been activated.
Restoral at point in area specified.
A Low Battery condition at the point specified has been detected.
The Low Battery condition previously sent from the point specified has restored.
A Request To Enter device has been activated but was denied due to the interlock door
being open.
A Request To Enter device has been activated but was denied due to the door being
Secured. See Door Secured.
A Request To Exit device has been activated but was denied due to the interlock door being
open.
A Request To Exit device has been activated but was denied due to the door being Secured.
See Door Secured.
Status report: alarm at area specified.
Status report: closing at area specified.
Status report: Fire Supervision at area specified.
Status report: opening at area specified.
Status report: area perimeter specified is armed with entry/exit delay.
Status report: area perimeter specified is armed (no delay).
Status report: Supervision at area specified.
Status report: trouble at area specified.
Serial Device Interface specified is not reporting. 1-8 = command centers; 017, 018, 019 =
printers; 33-40 = Access Control Module. 80 = Home Automation;
88 = RAMIV/Netcom. Make sure the device is plugged in.
The problem with the device specified is resolved.
User with reported ID reset detection devices in area specified.
A Service Walk Test in the specified area has ended.
A Service Walk Test in the specified area has started.
Sked* in area specified is bypassed.* System will not respond to faults at this device.
User with reported ID changed the Sked* indicated.
Sked* was activated.
Status report was sent to the receiver.
Supervision condition at point specified.
Area specified had four alarm or trouble signals within an hour. It is now bypassed from the
system.
Test report was sent.
User with reported ID changed the time in the security system.
D9131A User's Guide
Event Description and Troubleshooting
Page 7
D9131A
34584G
Advertisement
