Advertisement
Available languages
Available languages
Attach
custom
Visible side
Attach the 4 plastic studs to the wooden panel using the 4 short
hex head (5A6") screws provided.
Attach custom
tape
Align the studs on the custom wood panel to the keyhole slots on
the door assembly. Ensure that all 4 plastic studs are engaged in
the keyhole slots. Slide wood panel down until the top surface of
the wooden panel is flush with the top of the door.
Customer-supplied
panel
Drill through
these holes.
Remove 2 short screws
and replace with long
screws provided.
Check custom tape alignment with metal door slots; verify tape
is right-side up, and that the tape does not overhang the metal
door on the top, bottom or side interfaces. Remove the backing
from the custom tape by pulling straight down on the liner. Align
the custom tape to the keyhole slots on the metal door (see
image) and apply. Repeat steps for one side and then the other.
NOTE: The adhesive on the tape is aggressive, so proper
alignment and attachment
to the metal door needs to occur on
the first try.
Open the door and align top edges. Predrill 2 pilot holes using a
3/32"drill bit. Use tape to mark the drill bit to gauge hole depth.
Drill pilot holes approximately
11/2 '' (3.8 cm) into the top corners
of the door using hole in liner as a guide.
Advertisement
