Table of Contents
Advertisement
Aiming the Antenna
This section contains
instructions
for aiming the antenna.
There are
four procedures
you need to complete:
Connecting
the Antenna
to the Satellite Receiver
Q
Pointing the Antenna
Q
Fine-tuning
the Antenna Using the Signal Seeker
TM
Fine-tuning the Antenna
Using the Signal Strength Meter
Tools needed to aim the antenna:
Wrench (s/s")
or
Phillips screwdriver
Connecting the Antenna to the
Receiver
Note
• This is a temporary connection which
allows you to view the receiver's on-
screen displays. Refer to the Sony
Distal
Satellite Receiver operating
instructions for complete connection
information.
Connect the antenna to the satellite receiver to fine-tune the aim of
the antenna.
1
Turn off both the TV and _ceiver,
and unplug the receiver's AC
cord.
2
Connect the RG-6 coaxial cable from the satellite antenna to the
SATELLITE IN jack on the back of the receiver.
RG-6 Coaxial C able
FromSatellite Antenna
II @ II
._ T'-n=@"
illllllllt!
-"='-.,
, ,
!
-.,..-
--- •
:-:':
o%-
o
t
CoaxialCable l
To TV
Satellite
Receiver
AC Cord L
3
Connect a cable from the VI-ff: (SAT)/UI-IF OUT jack on the back
of the l_ceiver to the UHF/VHF
jack on the back of your TV.
4
Plug in the receiver's AC cord, and turn on both the TV and receiver.
S
Tune the TV to channel 3 or 4 to match the setting of the CH3/
CH4 switch on the back of the receiver.
36
Chapter 3: Aiming the Antenna
Advertisement
Table of Contents
