Sony LIB-81 Quick Start Manual
Ait library
Hide thumbs
Also See for LIB-81:
- Operating instructions manual (102 pages) ,
- Quick start manual (44 pages)
Table of Contents
Advertisement
Quick Links
Download this manual
See also:
Quick Start Manual
Advertisement
Table of Contents
Related Manuals for Sony LIB-81
Summary of Contents for Sony LIB-81
- Page 1 4-666-479-14(2) AIT Library Quick Start Guide ______________________________________ LIB-81...
- Page 2 INFORMATION You are cautioned that any changes or modifications not expressly approved in this manual could void your authority to operate this equipment. WARNING To prevent fire or shock hazard, do not expose the unit to rain or moisture. To avoid electrical shock, do not open the cabinet. Refer servicing to qualified personnel only. Caution The mains plug on this equipment must be used to disconnect mains power.
- Page 3 INFORMATION This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
-
Page 4: Table Of Contents
What’s next? ............9 Trademarks • Advanced Intelligent Tape is a trademark of Sony Corporation in this country, other countries, or both. • Other product names are trademarks or registered trademarks of their respective owners in this country, other countries, or both. -
Page 5: Unpacking
Operating Instructions (PDF) on the CD-ROM and in the future. Retain them for future use. make necessary settings. Remove the AIT library from the box as indicated • LIB-81 main unit (1) on the box. • Power cable (1) Remove the packing materials, such as plastic •... -
Page 6: Power
Installing the AIT library Connecting the Power Cable The library weighs about 13.5 kg (29.8 lb.) and has the following dimensions. Before installing the library, make sure that the surface on which you are placing it is Confirm that the power switch on the rear of the large and strong enough. -
Page 7: Connecting To The Host Computer
Attach the SCSI cable and terminator as shown in Connecting to the Host the figure below. 1 Use a SCSI cable (sold at stores) to connect the Computer AIT library to the host computer. 2 Attach the provided terminator to connector. Connect the AIT library and the host computer with a SCSI cable. -
Page 8: Turning The Power On/Off
If you want to change the date and time, press the Turning the Power On/ [ENTER] button. If you do not want to make changes, press the [CANCEL] button. For details about the date and time settings, refer to “Setting the Date and Time” in “Installation” in chapter 2, in the “Operating Instructions”... -
Page 9: What's Next
Select “2. Shutdown”, then press the [ENTER] What’s next? button. System Down 12:34 Read the Operating Instructions, install cartridges, make 1.Reset network connections as necessary, then make settings 2.Shutdown required to use the library. Procedures for making settings and using the library are given in the Operating Instructions (PDF) together with usage precautions and When “[ENTER] to activate”... - Page 10 For information about the AIT library, refer to your reseller. Sony Corporation...