iNSTALLATiON
AND
SERVICE MUST
BE PERFORMED
BY A QUALiFiED
iNSTALLER.
iMPORTANT:
SAVE FOR LOCAL ELECTRICAL
iNSPECTOR'S
USE.
READ AND SAVE THESE iNSTRUCTiONS
FOR FUTURE REFERENCE.
FOR YOUR SAFETY: Do not store or use gasollne or other flammable
vapors
and liquids
in the vicinity
of fhls or any
other
appliance.
_f the
informationin this manual is not
followed
exactly,
a _re
or explosion may result causing property
damage, petsona_ injury or death.
FOR YOUR SAFETY:
m
Do not store or use gasoline or other flammable
vapors
and liquids
in the vicinity
of fhls or any other appliance.
WHAT TO DO iF YOU SMELL GAS:
*
Do nat fry to light any appliance.
*
Do
nat
touch
any
elec|rlcal
switch;
do
not
use
any
phone in your
building.
"
Immedlately
call your gas supplier from a neighbor's phone.
Fellow
the gas suppller's instructions.
*
If you cannot reach your gas supplier, call the fire department.
Insfallaflan
and service must be performed
by a quallfled
installer,
service agency
or the gas supplier.
Note: For appliance
installed in the
State of Massachusetts
see page 2.
Front
view
49"
Maximum
A_
36t 1/8"
/
,\
30" minimum
clearance
between
the top of the cooking
surface
and the bottom
of an unprotected
wood or
metal cabinet; or 24" minimum
when bottom
of wood
or metal
cabinet
is protected
by not less than 1/_" flame
retardant
millboard
covered
with not less than no. 28
MSG sheet steel, 0.015" stainless steel, 0.024"
aluminum
or 0.020"
copper.
The minimum
clearance
is 0" for the
rear of the range. Follow all dimension
requirements
provided
above to prevent
property
damage,
potential
fire hazard,
and incorrect countertop
and cabinet
cuts.
Clearances
and Dimensions
1. Locatlon_Check
Iocatlon
where
the range
will be
installed. Check for proper electrical and gas supply, and
the stability
of floor.
Printed in United States
Avoid Iocatlng cabinet
storage
space above
the surface
burners
to eliminate
the possibility
of cabinets
catching
on fire, or personal
burns from reaching
for the cabinets
over
the heated
units.
Avoid
Iocaflng
cabinet
storage
space above the surface
burners.
The absence of cabinets
will eliminate
the chance of cabinets catching
on
rite,
and
eliminate
the possibility of receiving
personal burns from
reaching
for the cabinets
over flaming
surface
burners.
if cabinet
storage
is to be provided,
risk can be reduced
by insfalllng
a range
hood that
projects
horizontally
a
minimum
of 5" beyond
the bottom
of the cabinets.
2. Dimensions
that
are shown
must
be used.
Given
dimensions
provide
minimum
clearance.
Contact
surface
must be solid and level.
318201790 (0912) Rev. A