Connecting Power Cord - NEC Express5800 140Rd-4 User Manual

CONNECTING POWER CORD

Connect the provided power cord to the server.
Observe the following instructions to use the server safely. Failure to follow these instructions may
result in death or serious personal injury. See pages 1-3 to 1-8 for details.
Do not hold the power plug with a wet hand.
Observe the following instructions to use the server safely. Failure to follow these instructions may
cause a fire, personal injury, or property damage. See pages 1-3 to 1-8 for details.
Do not plug the power cord in to an improper power source.
Do not connect the power cord to an outlet that has an illegal number of connections.
Insert the power plug into the outlet as far as it goes.
Use the authorized power cord only.
1.
Plug the provided power cord into the AC inlet on the rear of the server.
2.
Plug the other end of the power cord into the wall outlet.
3.
Secure the power cord with a lock spring.
To connect the power cord from the server to an interruptive power supply (UPS), use service outlets on the rear of the UPS.
The UPS servi ce outlets are categorized into two groups: SWITCH OUT and UN-SWITCH OUT. (They may be
"OUTPUT1" and "OUTPUT2".)
To control power su pply with an application (ESMPR
SWITCH OUT outlet.
For constant power supply, connect the power cord to a UN-SWITCH OUT outlet. (Connect the modem that is in service for
24 hours to this outlet.)
WARNING
CAUTION
Lever
O UPSController) that controls the UPS, connect the power cord to an
3-19
Lock spring
called