Nokia A032 Getting Started Manual page 38

Supplementary information
Starting in BIOS mode
1 Switch off the unit.
2 Press and hold the
switching on again.
3 Keep holding the
After one second, all the
off. After a further five seconds, all the
LEDs will come on again.
4 Release the
mode
Using Learn mode over a wired LAN
Once the Access Point has an IP address you
can configure in Normal mode using a web
browser from either the wired or wireless LAN.
Learn mode is especially useful before the IP
address is defined.
Normally in learn mode, the LAN is
disconnected and configuration occurs only via
a wireless station. In some circumstances you
might need to assign an IP address over the
wired LAN. In this case follow the procedure
described in this section. Note that when in
normal mode (not Learn mode) configuration
can be performed either by wireless or LAN
connection at any time.
1 Remove the wireless LAN card from the
Access Point.
2 Switch off the Access Point.
3 Start the Access Point in Learn mode.
Follow the instructions on page 19 if you're
unsure. In this instance, while in Learn
mode the
air tx
alternate to indicate that the radio is not
present.
button while
mode
button.
mode
LEDs will go
info
button.
and LEDs will slowly
air rx
info
31