Table of Contents
Advertisement
en
Water softening system
To ensure good washing results,
the dishwasher requires soft water,
i.e. containing low amounts of lime,
otherwise white limescale will be
deposited on the utensils and inner
container.
Tap water above 7_ dH (from set value
) must be softened.
The water is softened with salt
(regeneration salt) in the water softening
system of the dishwasher.
The setting and therefore the required
amount of salt depends on the degree
of hardness of your tap water (see table).
Set
The amount of salt dispensed can be set
from
to
depending on the
hardness of your water.
Sal is not required at the set value
Find out about the hardness value
of your tap water. Your water utility
company will help you with this.
Set value can be found in the water
hardness table.
Close the door.
Switch on ON/OFF switch
Press and hold down the Start button
4
Rotate programme selector
is indicated on the digital display
.
5
Release button.
The factory-set value
digital display
5
Change the setting as follows:
Rotate programme selector
the required value is indicated on the
digital display
5
Press Start button
The salt refill indicator
The set value is saved.
6
.
.
1
until
3
is lit on the
.
until
3
.
.
4
goes out.
9
Water hardness table
Hide quick links:
Advertisement
Table of Contents
