Bosch sensixx TDS11 Series Instructions For Use

Solving Minor Problems Yourself
Problem Possible Causes
Temperature control (H) Turn the temperature
set to minimum control to a higher
position
Iron does not Connection problems Check that the plug is
work or is not inserted into the mains
heating up socket correctly
The automatic Move the iron gently
shut-off system has from side to side to
been activated (*) re-start
There is no water in the Fill the water tank
tank
The temperature control Set the temperature
Iron is not
(H) is set too low, the control within the steam
steaming
pump does not work " " area, between "••"
because the temperature and "max"
limiter is working
You have pressed the Wait 5 seconds between
shot of steam button each press of the jet of
(E) repeatedly without steam button
waiting for 5 seconds
Water is
between each press
dripping from
the holes in the
The temperature Change the temperature
soleplate
regulator (H) has been regulator setting.
set to "calc'n clean"
position while the iron is
still hot.
Temperature regulator Turn the temperature
(H) very low control to a higher
Water comes
position and wait until
out together
the lamp (A) goes out.
with steam
Steam regulator (A) set Turn the steam regulator
too high in conjunction (A) to a lower position.
with a low temperature.
There is no water in Fill the water tank
Iron emits noise the tank, the pump is
operating dry
Temperature too high Turn the temperature
Garments tend control (H) down, and
to stick wait until the iron has
cooled down.
During first use: Certain This is completely
components on the normal and will
The iron begins appliance have been stop after a short while.
to smoke when lightly greased at
switched on the factory and may
produce a little smoke
when initially heated.
Auto-shut off has been Move the iron gently
Flashing lamp activated. fromside to side to re-
on top of handle start it.
(*) The lamp will then flash
once before it re-heats
(*) Model dependent
You can download this manual from the local homepages of Bosch
Thank you for buying the TDS11 steam generator iron from Bosch.
These instructions contain valuable information about the unique
features of this iron and some hints to make ironing easier for you.
Please visit www.bosch-home.co.uk for more product
information or to register your product, just follow the link to
the Online guarantee registration.
Before using the iron for the first time
Please carry out the following steps:
1. Remove the protective cover from the soleplate before using the
iron.
2. While the iron is unplugged, fill the water tank (J) with tap water.
3. Plug the appliance into the mains and set the temperature control
(H) to the "max" position, by lining it up with the pointer (F) on the
iron.
4. Wait until the iron has reached the correct temperature. The
indicator light on the steam regulator (A) goes out. Then, set the
steam regulator (A) to the "+" position.
5. Hold the iron horizontally and press the pump button (G). Any
residue should come out of the soleplate (I). It may smoke and
smell – this is normal and will cease after a short while.
6. When using the steam function for the first time, do so away
from the garment, as there could still be some dirt in the steam
dispenser.
7. If necessary, carefully clean the soleplate down with a dry, folded
cloth
Cleaning and Maintenance
Attention ! Risk of burns !
For general cleaning, follow the information below:
Problem Solution
Dirty/lightly marked Clean the body of iron or soleplate with a
iron body or soleplate damp cloth then dry it.
Mark develops on Set the iron to its maximum temperature
soleplate during use setting. Rub the iron a few times over with a
dry cotton cloth folded several times.
Heavily stained While the iron is cold, iron a linen cloth
soleplate soaked in white vinegar. Then dampen a
cloth with water and wipe the soleplate clean
and dry thoroughly.
DO NOT de-scale or clean the water tank with cleaning products or
solvents, (unless recommended by Bosch) as these could cause the
iron to drip when using the steam function.
DO NOT use sharp objects or abrasive products to clean the soleplate
or any other part of the appliance. To keep the soleplate in good
condition, do not allow it to come into contact with metal objects.
Solution
GUARANTEE TERMS
The terms of the guarantee for this appliance are in accordance with
that stated by our representative for the country in which it is sold.
Details of those conditions can be obtained from the retailer from
whom the appliance was purchased. The SALES RECEIPT must
be presented when making any claims against the terms of this
guarantee. We reserve the right to make technical modifications.
Environmental Care
This iron has been designed according to ecological criteria, related
to the sustainable development, analysing its whole lifecycle -
from material selection to its later reuse or recycling - evaluating
the improvement possibilities, from a technical, economical and
environmental point of view.
Before throwing a used appliance away, you should make it noticeably
inoperable e.g. cut off the mains lead and be certain to dispose of it
in accordance with current laws and regulations.
Your retailer, town council or local council can give you detailed
information about these.
This appliance is labelled in accordance with
European Directive 2002/96/EG concerning
used electrical and electronic appliances (waste
electrical and electronic equipment - WEEE).
The guideline determines the framework for the return and
recycling of used appliances as applicable throughout the EU.
Tips to help you save energy
Steam production consumes the most energy. To help minimise
the energy used, follow the advice below:
• Start by ironing the fabrics that require the lowest ironing
temperature.
• Regulate the steam according to the selected ironing
temperature.
• Only use steam if necessary. If possible, use the spray function
instead.
• Try to Iron the fabrics while they are still damp and reduce the
steam setting. Steam will be generated from the fabrics rather
than the iron. If you tumble dry your fabrics before ironing them,
set the tumble drier to the 'iron dry' programme.
• If the fabrics are damp enough, turn off the steam regulator
completely.
• Stand the iron upright during pauses. Resting it horizontally
with the steam regulator on generates wasted steam.
Important
This appliance has been designed exclusively for domestic use and
must not be used for industrial purposes.
Carefully read through the operating instructions for the appliance
and safeguard them for future reference.
Customer Service
Great Britain
Bosch Customer Service
Grand Union House
Old Wolverton Road
Milton Keynes
MK12 5PT
UK +44 (0)844 892 8923
IRL +353 (0)1450 2655
www.bosch-home.co.uk
001 TDS11..GB/03/10
TDS 11..
sensixx steam generator
General safety warnings
• Danger of electric shocks or fire!
• This appliance is to be connected and used in accordance with
the information stated on its characteristics plate.
• This appliance must be connected to an earthed socket. If it is
absolutely necessary to use an extension cable, make sure that it
is suitable for 16A and has a socket with an earth connection.
• The iron should not be used if it has been dropped, if there are
visible signs of damage or if it is leaking water. It must be checked
by an authorized Technical Service Centre before it can be used
again.
• Do not allow the power cable to come into contact with the
soleplate when it is hot.
• In order to avoid that, under unfavourable mains conditions,
phenomena like transient voltage drops or lighting fluctuations can
happen, it is recommended that the iron is connected to a power
supply system with a maximum impedance of 0.27Ω . If necessary,
the user can ask the public power supply company for the system
impedance at the interface point.
• This appliance is not intended to be used by persons (including
children) with reduced physical, sensory or mental capacities, or
lack of experience and knowledge, unless they have been given
supervision or instruction concerning the use of the appliance by
a person responsible for their safety.
• Keep the appliance out of children's reach.
• Children should be supervised to ensure that they do not play with
the appliance.
• Remove the plug from the socket before filling the appliance with
water or before pouring out the remaining water after use.
• The appliance must never be placed directly under the tap to fill
the water tank.
• The appliance must be used and placed on a stable surface.
• When placed on its stand, make sure that the surface on which
the stand is placed is stable.
• The iron must not be left unattended while it is connected to the
supply mains.
• Unplug the appliance from the mains supply after each use, or if
a fault is suspected.
• The electrical plug must not be removed from the socket by pulling
the cable.
• Never immerse the iron in water or any other fluid.
• Do not leave the appliance exposed to weather conditions (rain,
sun, frost, etc.)
• With the aim of avoiding dangerous situations, any work or repair
that the appliance may need, e.g. replacing a faulty mains cable,
must only be carried out by qualified personnel from an Authorised
Technical Service Centre.
Instructions for use