Suspend Mode
Suspend mode suspends terminal operation. The terminal appears to be "off" when in suspend mode.
The terminal is programmed to go into suspend mode automatically when inactive for a specified period
of time. You can set this time period in the Power setting.
To Put the Terminal in Suspend Mode
Press the Blue
+ Backlight
Note:
You should always put the terminal in suspend mode when you change the battery pack; see
Main Battery Pack
To Resume Terminal Operation
To resume terminal operation (or "wake" the terminal from suspend mode),
• Press the Blue
• Press the Scan key
• If not in a scanning or imaging application, press one of the side buttons (see page 3-12).
Troubleshooting Suspend/Resume
If the terminal does not wake when you press the Scan key, the main battery might be too low to resume
operation. To check, remove the battery and install a fully charged battery or connect the terminal to a
Dolphin charging peripheral.
Care and Cleaning of the Dolphin Terminal
When needed, clean the image engine window and the LCD display with a clean, non-abrasive, lint-free
cloth. The terminal can be cleaned with a damp cloth.
3 - 26
keys.
on page
3-21.
+ Backlight
keys.
.
Changing the