Samsung SCB-3003 User Manual page 38

camera operation
COMM ADJ (Communication Adjustment) :
This function sets up the camera communication status when controlling the camera
through an external control device.
1) When the SPECIAL menu screen is
displayed, press the set button so that the
arrow indicates 'COMM ADJ'.
2) Set up the mode using the Function
Setup button.
- CAM ID : Determines the camera's identification
number (between 0 and 255).
- BAUD RATE : You can select 2400/4800/9600/
- UART MODE : You can select NONE, EVEN or ODD for the parity bits.
- RET PKT : Determines whether to send a command back to the controller device when a
communication control command is sent to the camera.
- DISP ID : Display camera title on top left corner of the screen.
- PROTOCOL : Select the communication PROTOCOL. (SAMSUNG-T, SAMSUNG-E , PELCO-D,
PELCO-P, BOSCH, HONEYWELL, VICON, PANASONIC, GE and AD)
- COAX : You can select whether to use COAX communication.
If you use the COAX communication, you prevent malfunctions by selecting
low sensitivity levels against noise.
- RETURN : Rreturn to the SPECIAL menu.
LANGUAGE : You can select the menu language according to your requirements.
RETURN : Return to the MAIN SETUP menu.
EXIT
Select a desired EXIT mode using the Function Setup button depending on the
camera purpose.
SAVE : Save the current settings and exit the MAIN SETUP menu.
NOT SAVE : Do not save the current settings and exit the MAIN SETUP menu.
RESET : Resets the camera settings to the factory defaults. Communication,
Language and Monitor settings are not initialized.
38_ camera operation
19200/38400/57600 bps.
COMM SETUP
1. CAM ID
IIIIIIIIIIIIIIIIIIIII
2. BAUD RATE 19200
3. UART MODE 8-N-1
4. RET PKT ENABLE
5. DISP ID OFF
6. PROTOCOL SAMSUNG-T
7. COAX ON
8. RETURN
1
t
T
If
If
T
T
T
c
T
w
T
C
T
W
a