Pioneer ANH-P9R Operation Manual page 47

MAN-ANH-P9R-GB.fm Page 47 Tuesday, June 4, 2002 1:39 PM
 
 
Press or until the desired frequency appears in the display.
40 – 80 – 100 – 160 (Hz)
200 – 500 – 1 k – 2 k (Hz)
3.15 k – 8 k – 10 k – 12.5 k (Hz)
 
Each press of or increases or decreases the level. "+6" – "–6" is displayed as the
level is increased or decreased.
 
Press or until the desired Q factor appears in the display.
2 N – 1 N – 1 W – 2 W
If you make adjustments when a curve other than "CSTM2" is selected, "CSTM1" curve is
updated.
You can adjust the cut-off frequency and the bass level.
In "FRT1" mode, bass adjustment affects only the rear output: front output cannot
be adjusted.

 
Press or until the desired frequency appears in the display.
40 – 63 – 100 – 160 (Hz)
 
 
Each press of or increases or decreases the bass level. "+6" – "–6" is displayed
as the level is increased or decreased.
You can adjust the cut-off frequency and the Treble level.
In and modes, treble adjustment affects only the front output: rear
output cannot be adjusted.

 
Press or until the desired frequency appears in the display.
2.5k – 4k – 6.3k – 10k (Hz)
 
 
Each press of or increases or decreases the treble level. "+6" – "–6" is displayed
as the level is increased or decreased.
Loudness compensates for deficiencies in the low- and high-sound ranges at low
volume.
"LOUDNESS ON" appears in the display.
Press again to turn loudness off.

 
Press or until the desired level appears in the display.
LOW – MID – HIGH