Advertisement
4 Connecting to a Windows NT Server 4.0
Windows NT
Requirements
Workstation
• HP Vectra with Microsoft Windows NT Workstation 4.0 installed.
Version 4.0
• IBM AUTO LANStreamer PCI Drivers diskettes Ver. 3.04
• Driver Name: OEMSETUP.inf Size: 67KB Date: 10/18/96
• Microsoft Windows NT Workstation 4.0 and Service Pack Media.
• Microsoft Windows NT Server 4.0 machine that supports Net BEUI, TCP/
Device Configuration
• I/O Base Address
• Interrupt Request Level
Procedure
1 With the HP Vectra turned off install the IBM LANStreamer 16/4 PCI TR
2 Insert the IBM LANStreamer TR drivers disk 1 of 6 (AUTO LANStreamer
3 After the machine boots, verify that the adapter finished testing and that
4 Click on "F3" to exit, and then press "CTRL+ALT+DEL."
5 After windows loads, log into NT workstation with administrator
6 Click on "Start", up to "Settings", and open "Control Panel."
7 Select the "Network" icon in the "Control Panel" program group.
8 Click on "YES" in the "Network Settings" dialog box, and NT Networking
9 With "Wired to the Network" checked, click on "Next."
10 Click on "Select from List", then click "Have Disk."
IP, NWLink IPX/SPX, and NWLink NetBIOS transfer protocols.
adapter card into a PCI slot.
PCI Diagnostic Disk) and power on the machine.
the adapter is "OK."
privileges. (If you do not have the required information, contact your
network administrator)
will be installed on your computer.
4 Connecting to a Windows NT Server 4.0
Windows NT Workstation Version 4.0
FC00h
9
Advertisement
