Cutting Wheel - Husqvarna SG 13 B Operator's Manual

5. Loosen the locking nuts (B) on the two tension
bolts.
6. Turn the two tension bolts (C) counter-clockwise to
loosen the belt or clockwise to tighten it.
IMPORTANT INFORMATION
If pulley on cutter head shaft must be moved,
the set screws MUST be fully removed, fresh
"Loctite 242" put on threads and re-torqued to
100 - 110 in./lbs. (17513 / 19264 N•m).
7. Check that the pulleys are aligned using a straight
edge along the inside face of the clutch and pulley.
Pulleys must be inline. Maximum gap or mis-
alignment is / " (.062) or 15.7 mm. Adjust using
1
16
the tension bolts as necessary. Check belt tension
again.
8. Tighten all screws and nuts when the adjustment
is complete. Be certain cover plate is not rubbing
against cutter wheel shaft.
9. Refit the belt guard.

Cutting Wheel

WARNING!
The cutters can come loose from
the cutting wheel if the bolts are not
sufficiently tight. Comply with the
recommended torque settings.
Tighten the screws 30 ft/lbs. (133 Nm).
40 -
HUSQVARNA
MAINTENANCE
A C B
CHECK CLUTCH &
PULLEY ALIGN
USING INSIDE FACE
TOOTH CUTTER
(CARBIDE FACE)
8011-228
8011-229