Display Open / Close; Panel Gap Adjustment - Mitsubishi Electric BR-LM1KK Quick Start Manual

3.2 Display open / close

Display closing
Release the lock bar at the right lower side of the front bar to
lift and push it.
Push the panel lightly to slide till locked at the end.
 Close it carefully not to touch adjacent panels.
 Make sure that the closed panel doesn't pinch the internal
cables.
 Release the lock bar while holding the display to the front if
it is hard to release it.
 Do not put your hands in the back of panel
while closing the display. You may be
injured to trap your finger in the bracket or
between the panels.
Front
Closing
direction
Front bar
Lift and push the lock bar
Lock bar

3.3 Panel gap adjustment

Flat surface shift
Loosen the nuts on V position adjustment screws with
wrench (8mm) before adjustment. Turn the adjustment
screws with a 4mm hex key. One turn of the screws shifts the
display approximately 0.8mm.
Close the panel to check the gap and repeat the steps until
the gaps being about 1mm.
H position adjustmnet scrw
V position : R
(other side : L
Nut
EN-10
Rear
The
Base bracket
1mm
1mm
H position
V position : L
V position : R
Display opening
Pull up the handes on both sides to draw the panel til
Release the display to pull up the handle(R) on the right sideof
the display. Open the display to draw the hadles on both sides.
Do not release the display to pull up the handle(L).
 Lock the front bar with lock bar not to pinch the fingers and
so on when the display is opened (refer to page 6 "3.1 step
2").
Handle (R)
Front / back direction
Loosen the nuts on adjustment screws with wrench (8mm)
before adjustment. Turn the screws with a 4mm hex key to
adjust. There are 4 screws in total on both sides. One turn of
the screws shifts the panel approximately 1.5mm. Tighten
the nuts after the adjustment.
 The shifting direction is opposite on upper and lower
screws. By clockwise turning, the upper screws shift the
panel top to the back direction, while lower screws shifts
the panel bottom to the front.。
Adjustmnet screws
(4 points)
After the all adjustment, firmly tighten the bolts on the
display brackets on both sides which have been fixed
temporarily and all nuts of adjustment screws.
Nuts