Remove Shipping Screws; Finalize The Installation; Reinstall The Drawer - GE SBSD137 Installation Instructions Manual

LEVEL THE WASHER OR DRYER
4
Locate the 4 legs from the parts package
A
and install.
Stand the washer or dryer upright. Move
B
it close to its final location.
C Make sure that the washer or dryer
is level by placing a spirit level on top.
Check side to side and front to back.
Use an open
D
ended wrench
to adjust the
legs in and
out. Tighten
the lock nut
against the
bottom of
the pedestal.
NOTE: To minimize vibration, the locking
nuts must be tight.
5

REINSTALL THE DRAWER

A Check to
be sure the
slides are
closed.
B Slide the
drawer
Drawer
into the
divider
opening.
Align the
drawer
supports to
the slides on
each side.
C Reinstall the original screws into each
drawer slide. Tighten both screws.
Open the drawer fully. Slide drawer
D
divider into slots in the center of the
drawer. The drawer should slide
smoothly when you push it closed.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
Installation Instructions
3

REMOVE SHIPPING SCREWS

6
Remove the 4 shipping screws on the back side
of the unit.
7

FINALIZE THE INSTALLATION

Refer to the washer or dryer Installation
Instructions to complete the installation.