Place Channels In The Vcr's Memory; Add Or Remove Channels From The Vcr's Memory - GE VG2053/VG4053 User Manual

Setting Up the VCR

5. Place channels in the VCR's memory.

The first time you turn on the VCR or after a power
interruption, perform the AUTO CHANNEL SEARCH so that
your VCR can memorize the channels available through
your signal source—cable or antenna.
Also, if you change the signal source, you will need to
perform AUTO CHANNEL SEARCH again.
A. Press MENU to display the VCR MAIN MENU on the TV
B. Press 3 to display the CHANNELS menu.
C. Press 1 to select the signal source, SIGNAL:CABLE or
D. Then, press 2 to begin AUTO CHANNEL SEARCH. If

6. Add or remove channels from the VCR's memory.

You may want to add or remove channels if some of the
channels are not active, have weak signals, or you do not
want to watch them.
You must place channels in memory using the AUTO
CHANNEL SEARCH feature described above before you can
add or remove channels.
A. Press MENU on the remote to see the VCR MAIN MENU.
B. Press 3 to display the CHANNELS menu.
C. Press 3 to display the ADD/REMOVE CHANNEL menu.
D. Select the channel you want to add or remove by
E. Press the MOVE left button to remove the selected
F. When you are finished adding or removing channels,
8
screen. If this menu does not appear:
• Make sure TV is tuned to same channel as CH3 CH4
switch on the VCR or the TV's video input (refer to
TV's manual).
• If you use a basic hookup, check the VCR indicator in
display panel — it should be on. Press TV•VCR to
turn it on.
• Check the connections.
ANTENNA.
you are using a cable connection as your signal source,
125 channels are searched for the strongest signals and
the letter C appears on the VCR's display panel. If you
are using an antenna connection, 69 channels are
searched.
Wait until the channel numbers stop changing. This
takes about one to two minutes. The TV tunes to the
lowest channel found. Then, pressing CHANNEL up or
down selects only the active channels.
If you need to change the signal source setting, select 1 in
the CHANNELS menu.
pressing the number buttons or using the CHAN up or
down buttons on the remote.
channel. Press MOVE right button to add the selected
channel.
press MENU to remove the menu and resume normal
viewing.
VCR MAIN MENU
1 SET CLOCK
2 TIMER RECORDINGS
3 CHANNELS
CHANNELS
1 SIGNAL: CABLE
2 AUTO CHANNEL SEARCH
3 ADD/REMOVE CHANNELS
PRESS MENU TO EXIT
CH 02
SEARCHING CHANNELS
PRESS MENU TO EXIT
VCR MAIN MENU
1 SET CLOCK
2 TIMER RECORDINGS
3 CHANNELS
CHANNELS
1 SIGNAL: CABLE
2 AUTO CHANNEL SEARCH
3 ADD/REMOVE CHANNELS
ADD/REMOVE CHANNELS
CH 03
IS CURRENTLY ADDED
5
PRESS TO REMOVE
PRESS MENU TO EXIT