Reset Sensors ? (Command + 4 + 7) - Bosch Security System User Manual

RESET SENSORS ? (COMMAND + 4 + 7)

Reset Sensors
Description
Detection devices, such as smoke detectors and shock
sensors, must be reset after being activated. This
function momentarily removes power from these
sensors to reset them.
COMMAND 47 also clears
point information from
the display, leaving the
*Alarm Silenced* message
in the display as a reminder that the View Memory
function can be used to view the cleared point
information.
4998122475C
RESET SENSORS ? (COMMAND + 4 + 7)
Using Reset Sensors:
1. Ensure your
command center
shows idle disarmed
text.
Press the COMMAND key.
2.
3. The display shows
*System Command*.
4. Press the 4 key, followed by
the 7 key.
Note: If you prefer, you may use the Command Menu
in place of steps 2 and 3 to initiate this function.
Press the Menu> key to enter the Command
Menu, then press Next> repeatedly until you
reach the RESET SENSORS ?> prompt. Press
the RESET SENSORS ?> soft key.
Security System User's Guide
Part II: System Commands
+