Removing The Battery For Recycling - Sharp AN-3DG30 Operation Manual

Using the 3D Glasses

Removing the Battery for Recycling

The following instruction and procedure is provided
solely as a guide for the safe removal of the Li-ion battery
for proper disposal. This product is not repairable.
Do not attempt to replace the battery; once
the 3D glasses are taken apart, they cannot be
reassembled or used again.
- Please take special care in handling small parts such as
screws specially around children that can accidentally
swallow them.
- Be very careful in handling the battery to prevent it from
leaking.
- Do not attempt to dismantle or puncture the battery.
- Do not use this battery for any other purpose. Recycle
properly after removing it from the 3D Glasses.
If you have any question regarding proper recycling
please call 1-800-822-8837 (U.S.A. and Canada only).
1
1Destroy the lower portion of the hinges using a
tool such as nippers.
2Remove the metal joints.
3Take away the nose pads and temple arms.
2
Remove the eight screws with a Phillips
screwdriver (commercially available).
3
Pull the front casing outward with your fingers .
1 Front casing
2 Rear casing
4
Cut off the two cables of the rechargeable battery
unit one by one with a pair of scissors.
• There is the rechargeable battery unit inside 2 on
the right side of the rear casing shown below.
• Insulate the tip of the removed rechargeable
battery cables, with material such as electrical
tape, be sure to insulate all two battery cable tips
to prevent the conductor wires from touching
each other.
1 Rear casing
2 Rechargeable battery unit
5
Pull out the entire rechargeable battery unit and
remove it from the rear casing.
NOTE
• Used batteries should be handled in accordance with
local laws and regulations.
EN-7