Getting started
Getting started
Switching on and off
The mains switch on the rear side of the receiver must be in
position „ON".
Press the "
between standby and operation mode.
In the operation mode, the green channel-location indicator of the
receiver is lit. Additionally, the red LED is lit.
Remote control
Two Micro type batteries are required for the remote control:
LR 03/AAA/1.5 V (included in the scope of supply)
Open the battery compartment.
Insert two batteries according to polarities mentioned on the
battery compartment. Push the cover of the battery compartment
carefully until the cover is locked.
Replace discharging batteries on time. Otherwise the sending
capacity of the remote control is too low.
Always replace both batteries simultaneously and use batteries of
the same type.
Check the batteries of your remote control at least once a year.
If one battery has leaked, wear protective gloves and clean the
battery compartment with a dry cloth.
28
" key of the receiver or the remote control to change