Vlan Commands - Motorola 549478-001-00 - PowerBroadband EthernetXD M2a WallPlate Switch User Manual

RADIUS network authenticated login
Tag-based VLAN Mode
Port-based VLAN Mode
V L A N c o m m a n d
V L A N c o m m a n d
All VLAN configurations are also available from the webUI.
vlan config default
vlan enable/disable
vlan add
vlan delete
vlan membership add
vlan membership egress
vlan membership delete
vlan interface ingress
vlan interface egress
vlan interface igmp
vlan interface mgmt
vlan mode
vlan port-group
Motorola, Inc.
Tag based mode is fully 802.1Q VLAN compliant. You must explicitly configure the
Egress and Ingress rules for each port and each VLAN. On the webUI, use the 802.1Q
TAG-BASED VLAN menu to configure VLANs.
The T3 Switch and WallPlate can operate independently. Be sure to configure all ports
on the Switch and the WallPlates for proper operation.
Port based VLAN is also called Port Isolation or Port Privacy in other switches.
When operating in port-based mode, the T3 Switch will ignore 802.1Q VLAN tags. Port
isolation is based on a VLAN Map. On the webUI, use the PORT-BASED menu to see
the VLAN Map and change the mapping. See below for more details.
Note: The Switch operates in port-based or tag-based mode; whereas the WallPlates
only operate in tag-based, or disabled. This allows for special case configurations
where the WallPlates do all the 802.1Q VLAN tagging, while the Switch maintains port-
to-port privacy.
s
s
Restore VLAN configuration to default
Enable or disable VLAN support. Requires a system reboot after issuing this command.
Create or modify a VLAN and optionally assign a name.
Delete a VLAN Group. Remove all ports that are members of the group before deleting
the group.
Add or delete a VLAN from a port. Allows the VLAN to transmit on the port
Sets how a VLAN will egress; with a tag or without. By default, packets will transmit
untagged unless specified using this command. Note this command does NOT apply to
WallPlate ports
Deletes a port from a VLAN membership
Ingress command: Assign the PVID for a port. This VLAN ID will be assigned to all
packets received untagged on this port
Set the Egress mode on any CPE port. This command does not apply to T3 Switch
ports
Assign VLAN for IGMP packets
Assign VLAN for layer 2 security for all management traffic
Set the mode of operation on the Switch and the WallPlates. Options are IEEE 802.1Q
tag-based, or Port-based. Note: WallPlates only support tag-based or disabled.
CLI command to add ports to a Port-based VLAN.
570510-001-00 rev A Page 38 of 50