Creating A New Qos Rule With The Hp 3Par Mc - HP 3PAR StoreServ 7200 2-node Administrator's Manual

Figure 10 Configure QoS
31
Enter non-negative integer values either for I/O Limit (IOs/Sec), within a range of 0–2 - 1 , or for
63
Bandwidth Limit (KBs/Sec), within a range of 0–2 - 1 , and then click OK.
When a QoS rule is configured, it becomes active immediately. If values for the I/O limit, bandwidth
limit, or both were defined previously, you can right-click the VVset name for a menu option to
configure, clear, or disable the rule, as shown in Figure 1 1 (page 155).
Figure 1 1 Configuration Options for Existing QoS on a VVset
You can change the values and save the rule by clicking OK. Changes made to an enabled QoS
rule take effect immediately.

Creating a New QoS Rule with the HP 3PAR MC

The Provisioning tree, in the HP 3PAR MC for an HP 3PAR StoreServ Storage system that has a
QoS license, has a new tree node labeled QoS. The table to the right of the QoS tree node lists
the configured QoS rules in the system, with their details (See Figure 12 (page 156)).
Using HP 3PAR Priority Optimization 155