Connecting Power
1.
NOTE
Use the power cord shipped with the jukebox.
2. Route the power cord through the strain relief clip ("4" on Figure 1-1) and close
3. Plug the socket end of the power cord into the power port on bottom of the
4. Continue to route the power cable down, through the long cable slot at the
5. Plug the other end of the power cord into a three-hole grounded outlet.
6. Press the power switch ON ("8" on Figure 1-1)
If DEVICE FAILED displays. See "Troubleshooting" in Chapter 3 for
NOTE
troubleshooting procedures.
7. Refer to Chapter 3, "Operating the Jukebox" for instructions on setting the SCSI
NOTE
Continue on to "Configuring Write Verify" on the next page.
Chapter 1
Ensure that the power switch on the jukebox is OFF ("5" on Figure 1-1)
the clip snugly around the cord.
power distribution assembly ( "9" on Figure 1-1).
bottom of the jukebox right side panel, and out through the cable access hole at
the lower left rear of the jukebox ("7" on Figure 1-1).
When power is applied, TESTING and NOT READY alternately display. Once
the poweron test completes (approximately 1.5 minutes), READY displays.
addresses, loading optical disks into the jukebox, setting a password, etc.
Setting Up the Jukebox
Connecting Power
1-17