Table 6 Jumper settings (Port 0 and Port 1)
PCI identifier
FE00
FE01
1AE5
NOTE:
Without a jumper, the HBA reports a device ID of 1AE5. Most software drivers require a PCI device ID of
FE00 to properly identify and control the HBA. Do not attempt to operate the HBA with the PCI device ID
set to 1AE5 unless recommended by the driver installation instructions.
Figure 3
shows the jumper settings.
Figure 3 Jumper settings
A8002A PCI-e single-port 4Gb FC adapter and A8003A PCI-e dual-port 4Gb FC adapter for Linux and
P0_JX (Port 0)
1–2
3–4
5–6
P1_JX (Port 1)
1–2
3–4
5–6
Windows systems installation guide
25