Accessing The Web Server Interface With The Default Ip Address; Web Server Configuration Guide - Samsung SCS-2U01 User Manual

Accessing the Web Server Interface with the Default IP Address

In the event that DHCP is not enabled, the following IP address is assigned to the Network Extender for Business.
192.168.1.10
Each Network Extender for Business is configured at the factory with the same user name and password, which are case sensitive:
User Name: administrator
Password: enterpriseFemt0 (zero at end)

Web Server Configuration Guide

IP Networks Configuration
This screen shows the current IP configuration of the device. If DHCP is enabled, the IP information is not shown.
The screen shows the following attributes:
1. Firmware Version: The version of the software loaded onto the Network Extender for Business
2. Current time: The system GMT time.
Starting Time: The last time the system was started
3.
MAC Address: The MAC ID of the unit - also found on the bottom of the Network Extender for Business
4.
DHCP Use: Indicates if DHCP is on or off
5.
IP Address: The IP Address of the unit, when assigned a static IP. When assigned a DHCP address, an address won't be displayed.
6.
7. Subnet Mask: The Subnet Mask of the unit, when assigned a Subnet Mask. When assigned a DHCP address, a Subnet Mask won't be displayed.
8. Default Gateway: The Default Gateway of the unit, when assigned a Default Gateway. When assigned a DHCP address, a Default Gateway won't be displayed.
DNS1/DNS2/DNS3: This option displays the DNS server address settings. The entry must contain an IPv4 address. DNS1 is required when not operating in DHCP mode.
9.
DSCP Use: This attribute displays the DSCP bit setting. When set to yes, the DSCP might have been customized. When set to No, the DSCP bits are assigned the default value of 46.
10.
DSCP: This attribute displays the DSCP bit setting, when using the customer DSCP option (when DSCP Use is set to yes as noted above).
11.
8