Panasonic ET-RPS100G Operation And Setup Manual page 10

2) Remove the power plug from the outlet.
3) Remove the power cord connector from the <AC IN> terminal on the rear of the device.
4) Remove the POWER SUPPLY. (Fig. 1)
f Use a Phillips-head screwdriver to turn the POWER SUPPLY fixing screw (x 1) counterclockwise until it turns freely, and then remove
the POWER SUPPLY.
f Hold the handles of the POWER SUPPLY and slowly remove.
5) Attach the cover for the POWER SUPPLY attachment section.
f Attach the stored cover for the POWER SUPPLY attachment section, and tighten to secure with the two screws with toothed lock
washers.
f To replace with another POWER SUPPLY, follow the procedure in "Attaching the POWER SUPPLY".
Attention
f When installing the unit to the Multi Window Processor to form a 2-POWER SUPPLY configuration, remove the power cord connector from
the <AC IN> terminal after turning off both POWER SUPPLY units to fully isolate them from the power supply.
10 - ENGLISH
Attaching the POWER SUPPLY